KC HiLiTES KC 324 Instructions

Instructions for

KC #323 (60w) or #324 (120w)

LED Light Bar System

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible. Your satisfaction with our product is important, so if you have any questions, please call our customer service line at 800-528-0950.

Parts Included

1 - LED Light Bar 2 - Brackets 4 - SS Bolts & Nuts 1 - Wiring Harness Kit

FOR OFF ROAD USE ONL

MOUNTING YOUR LIGHT

1. Add two SS bolts to the bar by inserting the bolt heads in the hole at the end of the bar and sliding along slot in bar as shown in fig A.

2. Add the other two bolts in each of the none slotted holes in each of the brackets. Lay the slotted part of each of the brackets over the bolts on the bar. (fig B) Loosely tighten nuts so brackets can easily be moved along bar.

3. Find a desired location for your light and if needed, drill two 5/16” holes, position the brackets on the bar as needed and mount the light. Up and down adjustments are made using the slots on the bracket. Tighten all nuts securely.

WIRING YOUR LIGHT

1. Remove the fuse from the harness. Find a suitable location inside the passenger compartment for

your switch. Mark and drill two 1/8” holes, insert screws and loosely install the panel to ensure fit. Remove panel, install switch, and slide panel with switch, back in place. (Do not tighten. The

panel and switch will be removed when attaching wires.)

2. Connect the wire to the light and route the harness back toward the 12V battery or power source.

Anchor the ground and power terminals near the battery/power source ensuring they are close enough to attach later. (DO NOT CONNECT TO BATTERY AT THIS TIME)

3. Continue routing the balance of the harness into the vehicle toward the switch. Once the wires are

inside the vehicle near the switch, remove the panel with switch and attach the green wire to the switch terminal marked SUPPLY. Attach the red wire to the switch terminal marked LOAD. Attach one end of the brown wire to the switch terminal marked EARTH and the other end to a good grounded metal surface under the dash. Re-attach the panel with switch and secure with screws.

4. Before attaching wires to the power source, ensure the switch is in

the OFF position (see photo) At your 12V power source, connect the green wire to positive 12V and the black wire to a good chassis ground or negative post on the battery.

5. Replace the fuse and turn on your lights.

Fig. A

Fig. B

OFF

Hole in Light for Bolt Head

Bolts with Nuts

on Brackets

6. You’re done.

KC HiLiTES, Inc., 2843 West Avenida de Luces, PO Box 155, Williams, AZ 86046 * 800-528-0950 * www.kchilites.com KC3265AP - 022213