KBC WESII 11, WESII 17dBi User Manual

Qty Description

Quick Start Guide

WESII-*A-** 17dBi/11dBi Point to Point Host

Introduction

Welcome to KBC Networks’ Quick Start Guide for the WESII point-to-point Host with an integral 17dBi antenna, for 5GHz & 4.9GHz operation and an integral 11dBi antenna for 2.4GHz operation. This document provides some quick tips on how to get up and running. For more detailed information see the Downloads section below.

Note: 4.9GHz units are only available in the USA.

Features

• 2.4GHz, 4.9GHz or 5GHz operation

• MIMO technology

• Dynamic Frequency Selection

• Transmission Power Control

• Antenna alignment & signal survey tools

• IP66 casing

Downloads

Installation manual - Other features and functions are described in the unabridged manual:

http://www.kbcnetworks.com/downloads

Specification Sheets:

http://www.kbcnetworks.com/downloads

System Contents

1 WESII Single Host/AP RF Module

1 Mid-span compliant Power Injector Module (PIM)

1 24VDC PSU for each Power Injector Module included

1 Cable weather proof kit assembly

1 Wall or pole-mount bracket and assembly kit each including:

1 Bracket body

1 Pole clamp bracket

1 Connecting piece 1

1 Connecting piece 2

1 50mm, 1.98” long ¼” hex bolt

3 ¼” hex nuts

1 27mm, 1.06” long ¼” hex bolt

3 Flat washers 15mm, 0.59”

3 Locking washers 10mm, 0.39” long

1 U bolt

4 ¼-20 lock washers

www.kbcnetworks.com

Equipment Required for Physical Deployment

You will need 2 straight-through Ethernet cables:

KBC recommends shielded outdoor rated Ethernet cables when connecting near power outlets and when exposed to the elements.

Physical Deployment

This equipment must be installed and operated in accordance with instructions found in the KBC Networks’ manual. The orientation of the units must be as depicted, failure to comply with these instructions will invalidate warranty.

Part Number Configurator (Frequency, Power Connection & Firmware Options)

WESII-*A-

A: 5GHz B: 4.9GHz C: 2.4GHz

A: US Power Connection & Firmware B: UK Power Connection & EMEA Firmware C: Euro Power Connection & EMEA Firmware E: Australian Power Connection & Firmware

C: 17dBi Directional Antenna (4.9GHz & 5GHz) E: 11dBi Directional Antenna (2.4GHz)

Configuring the WESII-*A-**

Refer to provided documentation for pre-set configuration settings. The following procedures may be necessary if purchased from distribution stock or in order to set custom configurations.

1. Connect the first Ethernet straight-through cable from the ‘IN’ on the PIM to either a laptop or a PC LAN port.

2. Connect the second Ethernet straight-through cable from the ‘OUT’ on the same PIM to the Host LAN port.

3. Apply power to the PIM with the provided 24VDC PSU and allow 60s for the unit to boot.

4. Verify that the static IP address on the laptop is set to 192.168.1.x subnet.

5. Open a web browser to access the Host on its 192.168.1.200 IP address; this is the default address for the unit.

6. Enter the following to access the GUI:

ID: admin Password: admin

Note: Ensure that all other network interface connections including your laptop Wifi are disabled.

+ 3 hidden pages