KBC eCopper EERN1-LN1-X-MX-B Quick Start Manual

VC eCopper™

QSG-EERN1-LN1-X-MX-B_Series-Rev1904 www.kbcnetworks.com
Copyright © KBC Networks 2019

Quick Start Guide

EERN1-LN1-X-MX-B

EoU Transmitter & Receiver - 1 UTP Connecter and 1 RJ45

Introduction

The KBC EERN1-LN1-T-MX-B is a fully ruggedized Ethernet over UTP
transmitter and the EERN1-LN1-R-MX-B is a fully ruggedized Ethernet over UTP
receiver. This product provides connectivity for one 10/100Mbps IEEE
standard electrical copper port over UTP cable. Varying data rates are
supported depending on cable distance and quality. The plug-and-play design
ensures ease of installation with no electrical adjustment needed. LED
indicators are provided to clearly show the operational status of the unit.

The size of the product is suited for fitting inside camera housings and where
space is minimal.

Features

• 1 UTP port and 1*10/100M Ethernet port

• UTP data rate >30Mbps (600m)

• 12~24VDC power input

• Complete protection design including surge protection and lightning

protection

Downloads

Full specifications, features and additional information can be found on the
relevant product page on the KBC website as well as in the downloads section:

www.kbcnetworks.com

Page 2 of 8

General

Check the product upon receipt for any visible damage which may have been
caused during shipping.

Physical Deployment

This equipment must be installed and operated in accordance with
instructions found in this document. Failure to comply with these instructions
will invalidate warranty.

Application

LAN

EERN1-LN1-T-MX-B

EERN1-LN1-R-MX-B

Ethernet UTP

UTPEthernet

UTP Ethernet

Ethernet

Panel Views

Top View (Transmitter)

Page 3 of 8

Top View (Receiver)

Panel View

1 2 3

4 5

Network cable panel Ethernet panel

1 - Power input; 2 - LED indicators; 3 - Network cable connecter;

4 - Ethernet RJ45 port; 5 – Grounding

LED

Color

Status

Description

PWR

Green

On

Power supply is normal.

T-LINK

Green

On

EoU connection is normal.

Ethernet
Link/Act

Green

On/Blink

On: Ethernet link is normal.

Blink: Data is active.