Kaz MA06 User Manual

Indoor Insect Trap

MODEL MA06

OWNER’S MANUAL

GENERAL INFORMATION

The NOsquito Indoor Insect Trap will lure indoor flying insects with its special fluorescent
ultraviolet (UV) light and capture them in a non-escapable catch-tray. Insects may be left in the
catch-tray until they dehydrate and die or can be released outdoors. The unit is for indoor use only
and can be used year round.

HOW TO USE YOUR NOSQUITO INDOOR TRAP

1. Unpack unit, save carton and packing materials for storage.

2. Position the Indoor Insect Trap at a height of about 3-6 feet from the floor. For best results,
place unit in the darkest area of the room far from windows and other competing sources of UV
light. The Indoor Insect Trap is effective when used intermittently to control various outbreaks
but performs best when run continuously. Often insects will breed and “over-winter” or
hibernate inside your home. Also during brief periods of warm weather, mosquito, fly and
ladybug activity may increase.

3. Plug cord into an outlet or U.L. Listed extension cord as described in “IMPORTANT SAFETY
INSTRUCTIONS”.

4. To turn unit ON, slide the ON/OFF Lever (A) all the way to the right
(see Fig. 1). The light and the fan will turn on and Inlet Valve (B)
will open. In this position, the Indoor Insect Trap will lure and trap
insects. NOTE: in the ON position, the Catch-tray (C) is locked
cannot be removed.

5. To turn unit OFF, slide the ON/OFF Lever all the way to the left (see
Fig. 1). The light and the fan will turn off and the Inlet Valve will be
closed preventing the escape of live insects. In this position, the
Catch-tray is unlocked and can be removed for emptying or
cleaning.

6. To remove Catch-tray, ensure ON/OFF Lever is in the OFF position. Pull the Catch-tray straight
out by slightly pushing in the Finger Grips (D) located on either side of the tray (see Fig 1).

7. To empty Catch-tray, pull the Snap Tab (E) at the back and separate the top and bottom (See Fig

2). Please use caution when emptying the tray; make sure the insects (especially stinging
insects) are inactive. If you notice that beneficial insects have been captured, it is your choice to
release them outdoors or let them dehydrate in the unit. Clean the Catch-tray as necessary by
rinsing under running water
and dry with a paper towel.

8. To reassemble Catch-tray,
slide top and bottom together
until Snap-Tab is engaged. Be
sure ON/OFF Lever is in the
OFF position and the Inlet
Valve is closed. Slide Catch­tray back into unit by aligning
the bottom on the tracks until
it snaps in place (See Fig 3).

BULB REPLACEMENT

For maximum effectiveness, replace the bulb (Model B04) every 1500/2000 hours of use (at least
once a year) to maintain optimal UV attraction. Even though the bulb’s light may be visible to you,
its ability to attract insects diminishes over time.

1. Unplug unit. (VERY IMPORTANT)

2. Using a #1 Phillips screwdriver, remove the cap screw in the center rim above the NOsquito
logo. Lift lid (See Fig 1).

3. Twist bulb 90° (See Fig 2a) and pull upward until bulb is removed (See Fig 2b). Dispose of
bulb properly.

4. Insert new bulb into both socket ends and twist 90° to lock (See Fig 3).

5. Close lid and replace cap screw.

6. For any questions or concerns regarding bulb replacement, please call Stinger Consumer
Service at 1-800-477-0457.

ORDERING REPLACEMENT BULBS

The fluorescent ultraviolet bulb in your Indoor Insect Trap has been designed for maximum
attraction to flying insects. Do not replace the original bulb with normal lighting bulbs. Replacement
bulbs (Model B04) are available at participating retailers or can be ordered directly from Stinger
Division of Kaz, Inc by visiting www.StingerProducts.com or by calling 1-800-477-0457.

IMPORTANT SAFETY INSTRUCTIONS

Please read these instructions before using the NOsquito
Indoor Insect Trap.

1. Remove all packing materials from the unit. To avoid
danger of suffocation, keep packing material away
from babies and children.

2. This product is equipped with 2-conductor cord and
2-prong plug to fit the proper type receptacles. To
reduce the risk of electrical shock, only plug into a
properly installed outlet.

3. Always disconnect plug before cleaning, changing
bulbs or when not in use.

4. Use only extension cords that have plug and
receptacles that match the product plug. Do not use
extension cords that are damaged or defective.

5. Electrical rating of the extension cord must be as
great as the electrical rating of the product.

6. Do not abuse cord – never carry unit by cord or yank
it to disconnect from receptacle. Keep cord away
from heat, oil, sharp edges or wet surfaces.

7. Do not use if unit is damaged or wet.

8. Do not clean this product with water spray. Do not
place where it can fall into water. Do not immerse in
water.

9. The Indoor Insect Trap may be placed on furniture, a
shelf or on the floor, but always in a vertical position.

10. Ensure there is space around the unit for air to
circulate.

11. This device is intended exclusively for the use for
which it was created and the producer is not
responsible for any damage caused by improper use.
For indoor use only.

12. The Indoor Insect Trap is an appliance and should be
kept out of reach of children and pets.

13. HOUSEHOLD USE ONLY.

14. When using an extension cord the cord should
exceed the rating of the product, be suitable for the
plug and receptacle and the cord should be marked
with a SJW-A, SJEW-A only.

15. In addition a device for retaining an extension cord
connection to the power supply cord should be used.

Fig. 1 Fig. 2a Fig. 2b Fig. 3

Fig. 1

Fig. 2 Fig. 3

E

p 6

p 8

B

C

D

A

D

2

3a

3b

4