Kastle Systems AIO W User Manual

All In One Reader User Manual

The All In One reader is a RFID proximity card and Bluetooth reader for
Kastle access control systems. It is intended to be used in conjunction with
an interface board BLE Daughter Board which piggy backs on to a KZDM
or KZSRDR Board.

Notes on Use:

- Operating Temp: 0-49 degrees C

- Must use 22 AWG or larger with a wire run no longer than 2000 ft

- All Wiring shall be in accordance with the National Electrical Code,

ANSI/NFPA 70

- The Reader is to be mounted in a protected premise

- Power to be supplied from KZDM, KZSRDR or UL 294 or UL 603 Listed power

supply

- No connection to reader shield per transient test setup

To install and use the reader:

 Connect the reader wires using wire nuts or beanie wire connectors to the

existing wire run coming out of the mounting hole or receptacle box. Make sure to
connect all wire by color white to white, green to green, black to black, and red to
red.

 Remove the reader cover to expose the mounting holes. Push wire bundle back

in to mounting hole or receptacle box. Mount the reader to the wall / or door
frame by securing screws through both mounting holes. Replace the front cover
of the reader.

 Terminate the other end of the wire run with a terminal block as shown below to

the Daughter board TB2.

 After the reader is terminated and connected on both ends and power is applied,

the blue LED should turn on and the reader should be ready to use within 0 to 10
minutes (depending on system updates).