7
ENGLISH
PROBLEM REASON SOLUTION
Faulty bin thermostat
Check and eventually change the
bin thermostat
The ice makers works also when
the bin is fu ll
Bin thermostat not calibrated
Check the therm ostat and
eventually calibrate it
No electrical supply Check water system
Blocked water valve
Check and eventually change the
water valve
Faulty pressure switch
Check and eventually change the
pressure s w itch
The safety therm ostat operates
Scale in the water condenser
Clean the condenser w ith apposite
anti scale products
Low water level in the bin
See ” no water spraid from
spra yers”
Evaporator thermostat not
calibrated
Calibrate thermostat
Not standard water jets
Check that each jet sprays directly
without obstacles the center of the
copper cups
The ice maker is not in the correct
horizontal position
Check the feet and place in the
right horizontal position
Small quantity of refrigerant in the
cooling system
Repear eventula leaks and
recharge the refrigerant
The ice cubes are not complete
See also “decreasing of production”
High ambient temperature and/or
small air circulation
Change place of installation of the
ice maker or change am bient
temperature
Obstracted position of the machine
(e.g. inside a furniture)
Change place of installation or
permit air circulation
Dirty air condenser
Clean the condenser w ith
compressed a ir
High water temperature
Check water temperature and
change place of installatio n
Bin full of water Check drain pipe of the bin
Decreasing of production
Small quantity of refrigerant in the
cooling system
Repear eventula leaks and
recharge the refrigerant
The compressor is short-circuited
and/or grounded
Check and change the compressor
The pump is short-circuited and/or
grounded
Check and change the pump
The hot gas valve is short-circuited
and/or grounded
Check and change the hot gas
valve
The thermostats are grounded Check and change the thermostat
Other electrical componets are
short-circuited and/or grounded
Check and change the component
The circuit breaker operates
Circuit breaker differential is faulty Check and change the component