Kason 1655-1010 Installation Manual

1655-1010 Corner Bracket Mounting Instructions

Corner bracket requires 2” x 2” notched opening. The illustrative information is provided to assure perfectly sized
corners. The corner bracket was designed to accept a shelf with 1 ½” return but will also accept longer returns.
Boxed dimensions must be maintained regardless of return length.

Lay shelf upside on a flat clean surface. Place pre­notched corners over lip of the corner fitting. Butt
it firmly against the back of the fitting, the corners
should match perfectly. Position inner bracket
against notched corner and secure tightly with
supplied hex bolts. Repeat for remaining corners.

To avoid damage to center and for easy installation, place
table upside down on a firm protected surface. Insert tubular
legs into the table sockets and slightly tighten the set screws
on the leg sockets to hold in place. Place complete shelf with
center brackets over the table legs (caution-to prevent
damage to the center brackets lower shelf evenly to desired
height on the legs and hold firmly in place until all center
brackets are secured with supplied bolt. Tighten table leg
socket set screw until tip contacts tube. Apply additional 1­3/4 turns to set screw to achieve 500 pound load rating.
Gently invert table to the upright position avoiding stress on
legs until upright.

IS-1655-1010

24JUN16