Kasco LL1020 User Manual

TM

WaterGlow

LL1020 Submersible

Landscape Light

Owners Manual

Thermal Overload

Protection, Gasket, &

Potting Eliminate Leaks.

Contents

Important Safety Instructions . . . . .pg2

General Owner’s Instructions . . . . .pg2

Warranty Policy . . . . .pg3

Maintenance Recommendations . . . . .pg5

Installation Instructions . . . . .pg6

Troubleshooting Tips . . . . .pg7

Replacement Parts . . . . .pg8

Customer Repair Form . . . . .pg9

Kasco Marine, Inc.

C

Intertek

3020379

UL 676 8th Ed. 2003

www.kascomarine.com • [e-mail]

800 Deere Rd.

Prescott, WI 54021

PH [phone]

FAX [phone]

Rev 05/22/12

THANKS!
We at Kasco Marine, Inc. would like to both
thank and congratulate you on your purchase
of the Low Voltage Lighting. We appreciate
you choosing Kasco and for your purchase.
Your decision to purchase Kasco’s Low Volt­age Light will not disappoint you. Some
NEW features to Kasco’s Low Voltage Lights
are Thermal Protection from overheating and
added seal protection of the light fi xtures and
cord. We thank you for choosing Kasco for
your low voltage lighting needs and want you
to be completely satisfi ed with your purchase.

Important Safety Instructions

Please read and follow these extremely impor­tant safety and handling instructions for your
Kasco lighting. Following these instructions
will help ensure your safety and the quality
performance of your equipment.

Always disconnect power from light be-•
fore service or relamping.

Kasco Low Voltage Lighting must be used •
with a 12V AC Transformer with wattage
capacity greater than the sum of all light
wattages on the circuit. (Ex. Three 75W
bulbs on the same circuit would require a
transformer of at least 225W or greater.)
Caution should be used when dealing with •
any electrical equipment.
NEVER• lift or drag the light by the power
cord.
This Light is designed for submerged use •
(see installation instructions). The internal
temperature protection will disable the light
if it is not submerged and greater than 20
watt bulb is used.

General Owner’s Instructions

INSPECT THE SHIPMENT
Immediately inspect your Kasco Low Voltage
Lighting shipment for any visible damages.
Also cross reference the Parts Included sheet
with the parts supplied to check for shortages.
Shortages should be reported immediately to
your Kasco Marine distributor or representa­tive and damages reported to your carrier and
Kasco Marine.

CAUTION
Up to a 75W bulb can be used if the light
fi xture is submerged in water at least 1” to al­low for proper cooling. Failure to do so could
damage the light. Do not lift the light by the
electrical cord. Always use extreme caution
around electrical equipment and water situa­tions.

ASSEMBLY & INSTALLATION
Please see the proper Assembly and Instal­lation Instructions enclosed in this manual.
Each is specifi c for your model Light Kit.

USE AND OPERATION
Kasco Low Voltage Lighting must be used
with the proper size 12V AC Transformer. The
wattage of this transformer must be greater
the sum wattage of all the bulbs used on that
circuit. (Ex. Three 75W bulbs on the same
circuit would require a transformer of at least
225W or greater capacity.) The wires on the
Low Voltage Lighting must be wired into the
transformer per instructions included with the
transformer. The White and Black wires on
the Low Voltage Lighting are the HOT wires.
The Green wire is the GROUND wire.

This light is designed for submerged use. The
internal temperature protection will disable the
light if it is not submerged and a greater than

2

20 watt bulb is used.

Kasco’s Low Voltage Lighting also has added
sealing technology for longer life and less wa­ter leakage on the fi xture and the cord.

Kasco Low Voltage Lighting is lightweight,
energy effi cient, and easy to install and oper-
ate. We strive to produce products that exceed
customer expectations. We hope you enjoy
your Kasco Low Voltage Lighting.

Warranty Policy

cord is altered in any way from original ship­ment. Cuts in the power cord are not covered
under warranty.

The Low Voltage Lighting is damaged by un­authorized tampering.

Warranty Claim Procedure:

Check the Date Code stamped on the light fi x-
ture to determine the month and year of manu­facture. The stamp is on the fi xture just below
the mounting bracket.

3 Year Limited Warranty: Kasco® Marine, Inc.
warrants this Light Kit to be free from defects
in material or workmanship under normal use
and service. The Kasco Marine, Inc. obliga­tion under this warranty is limited to replacing
or repairing free of charge any defective part
within three (3) years from the date of ship­ment. Customer shall pay shipping charges for
returning the unit to Kasco or an Authorized
Repair Center.

THIS WARRANTY IS IN LIEU OF
ANY OTHER WARRANTIES, EXPRESSED
OR IMPLIED, AND ANY OTHER OBLIGA­TION OR LIABILITY WHATEVER ON THE
PART OF KASCO MARINE, INC. AND IN
NO EVENT SHALL KASCO MARINE, INC.
BE LIABLE FOR ANY SPECIAL OR CON­SEQUENTIAL DAMAGES.

Warranty is void if:

The Low Voltage Lighting is not maintained
properly according to the Maintenance Rec­ommendations supplied in this Owners Manu­al.

The Low Voltage Lighting is returned for
repair without the power cord or if the power

Sample Date Code

0506

The fi rst two digits represent the month of
manufacture. (Ex. “05” for May)

The third and fourth digits represent the year.
(Ex. “06 for 2006)

Once the warranty coverage has been es­tablished, the Low Voltage Lighting may be
sent to any Kasco Authorized Repair Center
for evaluation and repair. Please call Kasco
Marine at 715-262-4488 prior to shipping to
receive a Return Authorization Number and/or
Repair Form, then ship to:

Kasco Marine, Inc.
800 Deere Rd.
Prescott, WI 54021
Attn: Repairs

Or call Kasco Marine at 715-262-4488 to
locate your nearest Authorized Repair Center.
You can also email Kasco at sales@kascoma­rine.com.

3

Note: Only complete Low Voltage Light­ing assemblies will be accepted for warranty
repair. The power cord and all other compo­nents must be returned with the Low Voltage
Lighting as originally assembled. Any miss­ing parts will be replaced at the customer’s
expense and, if determined to have caused the
failure, could void the entire warranty. Some
parts are essential for structural support during
shipping and others, such as the power cord,
are essential to properly diagnose potential
causes of failure. It is not necessary to return
the control box or fl oat with the motor assem-
bly.

Please include the Repair Form received from
Kasco Marine or your local distributor with
the shipment. If no Repair Form is available,
include your name and physical address for
return delivery of the repaired Low Voltage
Lighting and a daytime phone number and/or
e-mail address for correspondence regarding
the warranty claim.

Any expedited shipping method for the return
of the unit is at the customer’s expense. Kasco
Marine will return units repaired under war­ranty at our expense via ground freight within
the continental United States.

Other Repairs:

Most failed equipment can be repaired at
substantially lower costs than replacement
with new. Please ship according to the instruc­tions in the previous section. Again, it is best
to send the unit in with the Customer Repair
Form near the end of this manual.

include a daytime phone number and/or e-mail
address. Estimate options are as follows:

We will contact the customer with a total after
the Low Voltage Lighting has been evaluated,
but before the work is performed.
We will repair the Low Voltage Lighting only
if repair costs are under a stated dollar amount.
Example: “Please repair if total is under
$150.00 before shipping charges.”

All estimates that are rejected for repair will
be destroyed unless otherwise directed by the
customer. If the customer would like the Low
Voltage Lighting returned, it will be restored
as closely as possible to the condition in which
it was received and shipped at the customer’s
expense for shipping and handling charges.

Billing:

All non-warranty repairs will be returned to
the customer and billed C.O.D. unless other­wise directed. Kasco Marine also accepts Visa
and MasterCard credit card payments. Kasco
Marine will call for credit card information
upon completion of the estimate at the cus­tomer’s request.

All other warranty and repair inquiries
should be directed to Kasco Marine, Inc. at
715-262-4488 or
[e-mail].

Kasco Marine offers estimates on repairs at
the request of the customer. The request for
estimate should be included in the form that
accompanies the returned Light Kit and must

4