LS-8015-ZW-MM-BG
Manual
Operation Guide
Page - 2 - of 8
LS-8015-ZW-MM-BG
General Information:
Exit setting mode: Enter * to exit the setting procedure, or
wait for 10 seconds
Low battery warning: When the voltage drops below 5.2V
after entering a valid code, the lock beeps for three times.
Unlocking indicator: Music sounds and motor rotate.
Locking indicator: Red Light flashing one time, and music
sounds and motor rotate.
Restore Factory Default
a. Disconnect 1pcs battery
b. Press and hold the reset button
c. While holding the reset button, reconnect the
battery
d. Until the lock beeps, release the reset button.
e. Press digit ‘1’ to restore factory default or other
digit to abort reset procedure.
f. The lock must be set up again after the reset is
complete.
Warning: After restore, all existing user codes and
programming code will be erased, default
programming code will be restored , but the
enrolling of lock with gateway will not be erased.
The reset button is located below the battery holder.
(See Picture)
Page - 3 - of 8
Types to operate the lock：
User code unlock: 6 digits user code
Emergency unlock: 8 digits programming code + 9 (for
emergency)
Wireless :Mobile or PC or PAD
Manual key: Turn the override key 90 degree clockwise, then
turn the handle
Terms:
Programming code: 8 digits. The programming code puts the lock into
a programming mode. If more than 10 seconds pass in between
programming entries, the lock will return to normal operational status.
For maximum security it is necessary to change the default
Programming Code.
User code: 6 digits. User code is the normal code for day-to-day
operations.
Z-Wave: Every unlocking need be through Z-wave Controller.
Index No.*: 2 digits. For each user code. It is associate with a unique
number, we call it index No. The Index No. is auto generated by lock
and starts with 01. The highest Index No. will be 20. Total user index
is 20 that can be added to each lock. (* Please log the user code along
with its index No. for deleting reference)
Storehouse mode (Lock-back mode): For each valid entry, lock will
automatically relock back in 5 seconds.
Manufacture Default Setting：
Default programming code: 12345678
User code: Up to 20pcs,6 digits
Loading...