Karma 403 Service Manual

MODEL 403

Latté Express

SERVICE AND INSTALLATION MANUAL

The model 403 is designed for use with hot choclate or cappuccino powder drink base flavors.

SPECIFICATIONS

ELECTRICAL:

DIMENSIONS:
12”W X 11 53/4”D X 19” H

UNIT WEIGHT 20lbs APPROXIMATE SHIPPING WEIGHT 30 lbs

HOPPER CAPACITY: 2 lbs

PLUMBING: 1/4” ID waterline

CONSTRUCTION: 20 Gauge polished stainless steel

120V

, 60HZ, 5AMP, 1400 WATTS

Producers of dependable dispensing equipment

for the food and beverage industries

KARMA dispensers are covered by one or more U.S. patents and applications and corresponding foreign patents and applications

.

P.O. BOX 433
WATERTOWN, WI 53094 USA
920-261-1424
800-558-9565
FAX [phone]
INTERNET WEB PAGE
Http://www.karma-inc.com
E-mail [e-mail]

START UP AND OPERATION

 Lift off top right cabinet cover and set aside.

This will expose product hopper for filling

 Remove hopper cover and fill product hopper

 Replace hopper cover and cabinet cover

Connect dispenser to a 1/4” ID waterlin e



 Plu g di spen ser’s power cord into 115 volt

grounded outlet

 Position power switch (on back of unit) to up

position which is ON position. NOTE: Pilot
light will come on indicat ing that the wa ter is
being heated. When the. water is heated to the
proper temperature, the light will go off. This
initial heat up time will take approx 15 min.

 Place cup under dispense spout and push a nd

hold dispense sw itch for two seconds. This will
prime product hopp er. Dispenser is now ready
for use.

2

CLEANING PRODUCT HOPPER

1. When refilling hopper, inspect auger spring and inside of hopper for a “crust”
buildup.

2. When neces sary, disassem ble hopper and wash all parts in a mild
dishwashing soap and warm water.

3. Rinse parts and allow to completely dry.

4. Reassemble product hopper.

5. Fill product hopper and install in dispenser.

6. Place a cup under the dispenser spout. Dispense and discard a serving to
prime the system.

DELIME WATER TANK

1. Place the ON/OFF master switch to (off) position.

2. Remove the product ho p per.

3. Pour 4 ounces of a non-toxic deliming solution into the tank. Turn power
switch to ON position.

4. Wait 2 hours

5. Empty the water tank by pushing dispense switch until tank is empty.

6. Refill with cold water.

7. Empty water tank by pushing dispensing switch until tank is empty.

8. Refill water tank. Plug in the electrical cord

9. Install product hopper

10. Dispense a serving to prime .

3