Kari 283 User Manual

User Manual
1. Bluetooth Version: V3.0
2. Brand: ISSC
3. Working distance: 10 meters straight
4. Keys: Power ON/OFF/Volume, Tone
5. Function keys description:
Rotate right: Power ON / increase volume
When the power is on, the product will connect to the microphone near to the
speaker.
6. LED indication
1. RED LED in charging, Blue LED in fully charge
2. Auto connection mode: Red and blue LED
3. Connection success: Flash twice in 3 seconds
4. Low battery LED: Red flash
7. Battery: AA Size 1.2V *4, 1300mAh
8. Charging port: DC 5V
9. Charge current: 1000mA
10. Charging time: around 4 hours
11. Sound delay: 80-100ms
12. Application: Bluetooth Microphone
13. Operation: Hold Power ON button until LED flash, and turn on Bluetooth speaker
for auto connection. After 3-5 seconds, RED/BLUE LED flash means connection
success. If it is not success, turn off both unit and turn on again. Rotate Volume
key for increase or decrease volume.
The device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the product.
NOTE: This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If the product does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures : -Reorient or relocate the
receiving antenna. -Increase the separation between the product and receiver. -
Connect the product into an outlet on a circuit different from that to which the receiver
is connected. -Consult the dealer or an experienced radio/TV technician for help.
Loading...