Kapsys SmartVision Quick Start Guide

Quick starting guide

www.kapsys.com

Note

It is suggested to read the full user guide before using
your MiniVision. An electronic version of this document
is also available online at www.kapsys.com clicking on
the Support tab.

Overview

1. Neck strap holes

2. Phone calls receiver

3. Phone screen

4. Control keys and navigation pad

Up: selects previous item
Down: selects next item
Left: decreases volume
Right: increases volume
Central « OK » button: validates the

selected item / A long press activates the
speech recognition

Picks-up a call / Activates a shortcut to
access the « Phone » application

Hangs-up a call / Activates a shortcut to
go back to the home screen / A long press
turns your MiniVision on and off

Opens the menu associated with the
current screen

Goes back to the previous screen
Deletes characters in an edit box

5. Alphanumeric keypad to input characters

6. Micro USB connector to charge your
MiniVision

7. Microphone for phone calls and voice
recognition

8. 3.5 mm jack to connect provided earphones

9. Camera

10. Loudspeaker

Box content

MiniVision is delivered with:

- A battery

- A 220/110 Volts main charger – 5 Volts USB

- A Micro USB cable

- A pair of stereo earphones with microphone

- A neck strap

- A Quick starting guide

Getting started

Insert your SIM card and the provided battery

1. Flip the phone over, place your ngernail in the notch

located at the bottom left of the phone and lift the back
cover up.

2. Push and lift-up the holder to unlock the SIM
connector. Insert the Nano SIM card face down with the
beveled corner placed at the bottom right. Push back
the holder to lock the SIM connector.

Note: Use the same process to place an external SD
card in the slot located on the right of the SIM card slot.

3. Insert the battery placing the lower section rst, with

the connection pads at the bottom right, then put the
front down to click it on.

4. Lastly, put the cover back, align its tabs with the
adapted slots, and gently press the cover until it snaps
in place.

Charging the battery

For initial use, it is recommended to charge the battery
for at least four hours. After that, you can recharge the

battery as needed.
Connect the USB cable between the MiniVision
and the AC charger. Plug the AC charger into any
AC outlet and charge the device. It is normal for
a phone to heat-up when charging or during long
periods of use.

Turning the phone ON/OFF

Turn ON your MiniVision with a long press on the
hang-up key (
navigation pad. The MiniVision vibrates when you
successfully turned it on.

When the phone is turned on for the rst time,

please follow the set-up instructions (language

selection, prole selection, etc.)

The MiniVision is ready to use when the home
screen is displayed.
When your MiniVision is ON, a short press of the
hang-up key ( ) puts it to standby mode (screen
off), or back to running mode (screen on). The
standby mode is activated after an inactive period
for the battery to last.
In standby mode, the MiniVision screen is off but
its features remain enabled. You can still receive
incoming calls and messages.
To turn the MiniVision off, make a long press on the
hang-up key ( ), then select “OK” and validate

to conrm the shutdown. The MiniVision vibrates

when you successfully turned it off
If the screen remains black or if your phone is no
longer responding, you can force a restart simply
removing the battery and putting it back.

) placed at the bottom right of the

Legal notice and Warranty

1. Use precautions and recommendations

- Handle your MiniVision and its accessories with
care, do not drop or knock them.

- Do not dismantle the product as this will result in
the warranty being voided.

- Clean the product using only a soft, slightly damp
cloth. Do not use chemicals, detergents or abrasive
products.

- This product is not waterproof. Protect it from
damp and splashes of liquids.

- Never use the device near a source of heat, and
avoid storing the device in hot, humid or corrosive
places.

- Do not use the product near magnetic elds.

- Do not use your device if the screen is broken or
cracked as this could cause injury.

- Do not use the product in potentially explosive
areas.

- Do not charge the product in temperatures below
0°C (32°F) or above 45°C (113°F).

- Do not use the product in health care facilities
and ask to authorized personnel before using your
phone near medical equipment.

- Do not expose your product to extreme
temperatures. (1) Operating temperature range is

-10°C (14°F) to +55°C (131°F); (2) short-term
storage temperature is -20°C (-4°F) to +60°C
(140°F) and (3) long-term storage temperature is

-10°C (14°F) to +25°C (77°F).

- Your product contains a built-in lithium-Ion battery.
To increase the battery life, always charge it fully.

- Prolonged use of the product may cause the

product to heat.

- For optimal performance of your device, we
recommend that you switch it off and remove the battery
from time to time.

2. SAFETY AND HEALTH

Keep the product away from small children.
Protect your hearing: avoid prolonged exposure to high
sound levels when using the earphones, loudspeakers
or the receiver.
If you wear a pacemaker or live near a person who
wears one, you may want to seek advice from your
doctor or the manufacturer of the pacemaker regarding
its compatibility with a wireless device.
Radio transmitting equipment may interfere with the
safe and effective use of some medical equipment when
not adequately protected.

3. WARRANTY

In case of breakdown, please contact your dealer.
No warranty is granted on the product, regardless of the
malfunction encountered, in the following cases:

- Normal wear and tear of the product and reduction in
the battery charge holding capacity,

- Damage resulting from improper use, exposure to
humidity or liquid, or proximity to a heat source,

- Cracked or broken devices, or devices with visible
signs of shocks,

- Failure to respect the use precautions, accidents,
negligence, misuse or use inconsistent with the
instructions provided with the device, or commercial use

of the product,

- Short-circuits of the battery or use of the battery in
another device than the MiniVision

- Use of accessories or connectors not supplied by the
manufacturer.

- Damage resulting from an attempted repair done by
someone else than the manufacturer or one of its
authorized repair centers.

It is recommended that you perform one or more
backups of the data saved in your product. The dealer
cannot be held responsible for the loss of this data
because of a malfunction, repair or replacement of the
product.

Any malfunctions related to network services and/or
cellular system cannot be guaranteed. The phone
network provider or the internet service provider will
need to be contacted directly for assistance.

4. ABOUT SPECIFIC ENERGY ABSORPTION RATE

Your MiniVision is provided with a radio transmitter/
receiver. It has been designed and manufactured
to comply with the radiofrequency (RF) exposure
thresholds recommended by the European Union.
This device meets the EU (1999/519/EC) requirements
on the limitation of exposure of the General Public to

electromagnetic elds by way of health protection. The

unit of measurement for European council’s
recommended limit for mobile telephones is the

“Specic Absorption Rate” (SAR). This SAR limit is 2.0

W/kg averaged over 10 g of body tissue. This device
meets the requirements of the International Commission

on Non-Ionizing Radiation Protection (ICNIRP) and EN
62209-1 / EN 62209-2 / NF EN 50566 European
Standards for mobile radio devices.
For body-worm operation, this phone has been tested
with the use of accessories that contained no metal
and that positioned the handset at a minimum of 1.5
cm from the body. Use of other accessories may not
ensure compliance with RF exposure. If you do not use
a body-worm accessory and are not holding the phone
at the ear, position the handset at a minimum of 1.5 cm
from your body when phone is switched on.
During use, the actual SAR level is usually much lower
than the maximum value. In general, the closer you are
to the base station, the lower the transmission output of
your mobile telephone. To reduce exposure to RF
energy, use a hands-free accessory or other similar
option to keep the device away from your head and your
body.

The highest SAR value of this device is listed below:
Head: 0.65 W/kg (averaged over 10 g of body tissue)
Body: 1.30 W/kg (averaged over 10 g of body tissue)

5. CUSTOMER SERVICE

For more details, please contact your vendor’s customer
service or send us a mail at: Service Clients
KAPSYS – 694 avenue du Docteur Maurice Donat
06250 Mougins Sophia Antipolis, France.
You can also visit our website at: www.kapsys.com.

6. TRADEMARKS

Company and product brands referred to in this
document and in other KAPSYS user guides, are

trademarks, either registered or not, and owned by the
respective holder as follows:
Kapsys names, brands and logos are registered
trademarks of Kapsys SAS.
Bluetooth names, brands and logos are registered
trademarks of Bluetooth SIG Inc.
Nuance is a registered trademark of Nuance
Corporation Inc.
All brand names and product names are trade names or
registered trademarks of the respective companies.

7. ABOUT THIS DOCUMENT

Information published in this document is subject to
change without notice. KAPSYS reserves the right to
amend the contents of this document with no
obligation to notify any person or entity whatsoever
thereof. KAPSYS cannot be held liable in the event of
any
technical or publishing errors or omissions contained
herein, or in the event of accidental or indirect loss or
damage resulting from the product operation or from
using this document. KAPSYS endeavors to
continuously improve its product and features quality
and performance. KAPSYS therefore invites you to visit
its website (www.kapsys.com) for the latest available
update on the use and operation of this product.

RoHS COMPLIANCE:

This product is compliant with the 2011/65/EU Directive
of European Parliament and of the Council of June 8,
2011, on the use restriction of certain hazardous
substances (RoHS) in electrical and electronic
equipment and its amendments.

CE MARKING

This product complies with the CE
marking requirements for use in
residential, commercial or light industry

installations, and satises with the

provisions of the R&TTE (1999/5/EC)
Directive. For more information about
CE marking, you can also visit our
website at www.kapsys.com.

WEEE DIRECTIVE

This symbol on the product or on its
packaging indicates that this product
must not be disposed of with your other
household waste. In accordance with
the 2002/96/EC European directive on
waste electric and electronic equipment
(WEEE), his electrical product must not,
under any circumstances, be discarded
as unsorted municipal waste. Please
dispose of this product by returning it
to its point of sale or to your council’s
local designated collection points for
recycling.

CAUTION: Permanent hearing loss may
occur if earphones are used at high
volume for a prolonged period of time.