KAPASS H50U Installation And Operation Manual
H50U Glass&Dish Washer
installation and operation manual
KAPASS COMMERCIAL DISHWASHER
V．001005
Contents
1 Safety Instruction………………………………………………………1
2 Brief introduction to the machine………………………………3
General…………………………………………………………………………3
Technical Data…………………………………………………………………4
3 Installation………………………………………………………5
Unpacking…………………………………………………………………………5
Location ……………………………………………………………………………5
Electrical Connections…………………………………………………………6
Plumbing Connections ………………………………………………………6
4 Operation……………………………………………………………8
Testing ………………………………………………………………………8
Control Panel……………………………………………………………………8
Preparation………………………………………………………………………10
Dish washing …………………………………………………………………
11
Cleaning …………………………………………………………………………12
5 Maintenance…………………………………………………………13
6 Trouble Shooting……………………………………………………14
Appendix: Electrical Diagram
H50U Glass&Dish Washer installation and operation manual
- 1 -
1 Safety Instruction
To ensure correct operating, the operators are supposed to
pay special attention to the following:
Safety
1, After purchasing, please contact professionals for guidance on installing and operating
the machine.
2, Relevant personnel must be regularly trained to understand the proper use and safe
operation.
3, Do not store or use gasoline or other flammable gases and liquids near the dishwasher.
4, Apply separate socket, the end of the ground wire must be reliably grounded. After
installed in place, the plug should be able to reach it.
5, Ensure that the machine is properly grounded to avoid electric shock. Please do not try
to disconnect the dishwasher plug by pulling power cord.
6, There should be overload devices like appropriate fuse in the dishwasher room, the
power supply system should be able to satisfy the need of the normal load requirements;
If you need to replace the power cord, please ask professionals or contact with our service
center.
7, Don't stretch your hands into the machine or open the door when the machine is
working, protecting users from electric shock and burns of water or steam .
8, To avoid accidents, please do not locate the dishwasher too close to the wall or install it
on tables above the ground.
9, For your safety, dishwasher disassembly is prohibited.
10, Security systems and electrical systems must be inspected regularly to ensure the
machine to stay at its best.
11, Disconnect the machine if there is obvious damage happened to the dishwasher,.
12, Disconnect the power supply before repairing the machine, non-professionals are
prohibited.
When operate the machine
1, The machine can only be used for washing cutlery, dishes and general utensils. If there
are damages caused by other purposes, we do not take any responsibility.
2, Apply only original parts. If there are damages caused by non-original parts, we do not
take any responsibility.
3, Only qualified and authorized personnels are allowed to use, maintain and repair the
machine.
H50U Glass&Dish Washer installation and operation manual
- 2 -
4, Before each operation, please check the water inlet hose and drain pipe if they are well
connected. Proper treatment should be done if there is water leakage or connection
looseness.
5, Do not place on top of the dishwasher heavy objects, heating appliances or items easy
to leak fluid.
6, Do not use flammable or toxic solvents as detergent.
7, Please replace in time the aging power lines or switches, and other spare parts aging or
damaged. To start machine in bad condition is strictly prohibited.
8, Don't start the machine when there are loose or damaged parts.
9, When the machine is not in use, please keep the door open. Disconnect the water and
power supply after finish operating.
Saving and Protecting
Water, electricity and chemicals saving will be beneficial to environmental protecting
and costs reducing.
1, Remove large food residue before cleaning tablewares, and then classify tablewares.
2, Decide the amount of detergent according to water hardness, dirtiness and quantity of
dishes , and follow instructions on the package.
H50U Glass&Dish Washer installation and operation manual
- 3 -
General
Your new H50U is a semi-automatic, rack type under counter glass&dish washer. Open
the front door to allow the rack to be pushed in or out. After filling, an automatic wash and
rinse cycle begins when the door is closed. In case of low water level, water will be filled in
automatically when the door is closed, an automatic wash and rinse cycle will begin after
reaching normal level.
The dishwasher is equipped with built-in 6KW or 3KW electric booster, inlet solenoid
valve and strainer basket.
2 Brief Introduction to the Machine
H50U Glass&Dish Washer installation and operation manual
- 4 -
Major Technical Data
Technical Data
Unit H50U
Washing data
Max capacity rack/hour 40
Wash cycle s 90/120/180
Wash Temp
°C
60～65
Rinse Temp
°C
82～90
Tank capacity L 28
Water consumption/rack L 2.8
Plumbing
connections
Diameter of the water inlet hose
in 3/4
Incoming water pressure
Kg/cm2
2～5
Incoming water Temp
°C
40～60 10～60
Diameter of drain pipe
in 11/4
Power
connection
Power requirements V/Hz/Ph 220/50/1 380/50/3
Tank heater KW 3 2.8
Rinse heater KW 3 6
Wash pump KW 0.4
Total connected load KW 3.4 6.4
Total amps required A 16 10
Cross section of cable
mm2
4 2.5
Rated current of circuit
breaker
A
25 16
Others
Max clear entry height
mm 330
Working Noise db
＜70
Dim（L×W×H）
mm 600×600×820
Loading...