Kanto YU6 User Manual

YUMI

POWERED SPEAKERS

English

User Manual

YU6 Powered Speakers

Supporting your digital lifestyle

™

Important Safety Precautions

The exclamation point within an equilateral

triangle is intended to alert the user of

the presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the apparatus.

• Read these instructions.

• Keep these instructions.

• Heed all warnings.

• Follow all instructions.

• Do not use this apparatus near water.

• Clean only with a dry cloth.

• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including

ampliers) that produce heat.

• Protect the power-supply cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

• Only use attachments / accessories specied by the manufacturer.

• Use only with the cart, stand, tripod, bracket, or table

specied by the manufacturer, or sold with the apparatus.

FCC Notice:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for help

NOTE 2: Any changes or modications to this unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

ATTENTION

CAUTION: TO REDUCE THE RISK OF

ELECTRIC SHOCK, DO NOT REMOVE BACK PANEL.NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.

• Unplug this apparatus during lightning storms or when unused for long periods of time.

• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, the apparatus does not operate normally, or the apparatus has been dropped.

• Apparatus shall be connected to a MAINS socket outlet with a protective earthing connection.

• An appliance input coupler is used as the disconnect device - the disconnect device shall remain readily operable.

• Batteries or battery packs shall not be exposed to

excessive heat such as sunshine, re or the like.

equilateral triangle, is intended to alert the user of the presence of non-insulated “dangerous voltage”

sucient magnitude to constitute a risk of electric

DANGEROUS VOLTAGE

The lightning ash with arrowhead, within an

within the product’s enclosure that may be of

shock to persons.

Industry Canada Notice:

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or

lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that

necessary for successful communication.

This device complies with Canadian ICES-003 and RSS-210

Le pré sent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence L’ exploitation est autorisé e aux deux conditions suivantes:

(1)l’ appareil ne droit pas produire de brouillage, et (2)l’ utilisateur de l’ appareil doit accepter tout brouillage radioé lectrique subi, mê me si le brouillage est susceptible d’ en le

fonctionnement .

Introduction

Thank you for choosing YU6 Powered Speakers, designed by Kanto in Canada. YU6 outputs 200W Peak power into 6 Ohm speakers, for remarkably bold and clean sound. Excellent

sensitivity and frequency response provide deep thumping lows and clear, scintillating highs.

YU6 is an amazingly exible speaker system that can accept ve input sources and connect to

a subwoofer for enhanced low frequency response. Additionally, it is equipped with the latest

Bluetooth technology and a USB port for charging your devices. YU6 has a universal input power supply and can be used worldwide from 110V AC to 240V AC.

We recommend you read all instructions carefully before using the system and keep them for future reference. Kanto cannot be liable for damage or injury caused by incorrect setup or use of this product.

This powered speaker system was carefully tested and inspected during production, and before packaging and shipping. After unpacking, please check for any damage. It is rare that a unit is damaged during shipping, but if this happens contact your retailer immediately. You can also contact Kanto directly using one of the methods below.

Email: support@kantoliving.com

Toll Free: US & Canada: 1-888-848-2643 | UK: +44 800086999

What’s In the Box?

AUX

RCA

OPT2OPT1

TREBLEBASS

BALANCE

YU6 Active

YU6 Passive

Speaker

(Left Channel)

(Right Channel)

Self-Adhesive

Rubber Feet

Supporting your digital lifestyle

Speaker

Power

Cord

™

YU6

Remote

Speaker

Wire

‘AAA’

Batteries

User

Manuals

3.5 mm cable

AUX

Front & Rear Panels

FRONT PANEL

1 1” Silk Dome Tweeter

2 5.25” Kevlar

Mid/Woofer Driver

3 LED

White - Power on / Playback Mode

Yellow - Standby (solid)

- Mute (ashing)

Blue

- Discover Mode (ashing)

- Paired (solid)

4 Volume / Input Select / Standby /

Wake-up

REAR PANEL

5 RCA L/R Input

6 3.5 mm AUX Input

7 Subwoofer Output

8 Optical 1 and Optical 2 Inputs

9 RCA input Phono/Line switch

10 Turntable Ground Post

11 Right Channel Output Terminals

(+ and −) for Passive Speaker

Connection

12 USB Charge Port (5 V 1.0A)

13 ON / OFF Switch

14 AC Input Connection (100 V - 240 V)

Volume/Input Select Knob

YU6’s volume knob functions as an input select knob as well.

Push the knob to select an input source

- it cycles through the following inputs depending on what input source was last used.

RCA AUX OPT1 OPT2 BLUETOOTH

Push and hold the knob to enter standby or wake up from standby

10 11

5 6

RCA

AUX

Sub Out

OPT1

OPT2

GND

USB Charge

5V / 1A

ON OFF

Phono Line

RCA

Right Channel Out

www.kantoaudio.com Designed in Canada

Made in China

+ 8 hidden pages