Kanto T3760 User Manual
English
User Manual
T3760 TV Mount
TILTING FLAT PANEL TV MOUNT
+10°/-5°
100 x 50
-
600 x 400
150 lb
(68 kg)
VESA
Supporting your digital lifestyle
™
Table of Contents
Table of Contents / Introduction . . . . . . . . . . . . . 2
Supplied Parts & Hardware . . . . . . . . . . . . . . . . . 3
Setup - Step 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Setup - Step 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Setup - Steps 3 and 4. . . . . . . . . . . . . . . . . . . . . . . 6
Setup - Steps 5 and 6. . . . . . . . . . . . . . . . . . . . . . . 7
Other Kanto Products . . . . . . . . . . . . . . . . . . . . . . 8
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Introduction
Thank you for choosing a Kanto AV Systems tilting wall mount. The T3760 is designed to mount fl at panel televisions
weighing up to 150 lbs (68 kg) within less than 2” of your wall. This mount will tilt your TV +10º / –5º.
Read these instructions fully before installation of this mount. If you do not understand these directions, or have
any doubts about the safety of the installation, please consult a qualifi ed installation contractor to install this mount.
Make sure there are no defective or missing parts. Do not use defective parts. If you are uncertain whether the part
is defective call Kanto AV Systems directly at 1-888-848-2643 or support@kantoav.com. Kanto AV Systems can not be
liable for property damage or injury caused by incorrect mounting, incorrect assembly, lifting or incorrect use of this
product.
This product should not be mounted on steel stud walls or cinder block walls. Consult a qualifi ed installation contrac-
tor if you are unsure about the type of wall you may have. We make every eff ort to ensure all necessary hardware is
included. If there is hardware missing please call Kanto AV Systems directly at 1-888-848-2643 or support@kantoav.
com.
See installation video online at:
www.kantoliving.com
CAUTION
The maximum loading weight is 150 lbs (68 kg). This wall mount is intended for use only within the
maximum weight restrictions indicated. Use with products heavier than the maximum weights indicated may
result in instability causing possible injury. Recommended TV Size: 37 inch to 70 inch.
CAUTION
The wall you plan to affi x the Kanto mount to must be able to support more than 5 times the weight of
the television and the wall mount combined. Do not use this product for any purpose other than to mount a
fl at panel TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your
TV or serious injury. This product should not be mounted to steel stud walls, cinder block or old concrete walls.
Consult a qualifi ed installation contractor if you are unsure about the type of wall you may have.
2
Supplied Parts and Hardware
Wall Plate
x4 x4 x4
A: M5 x 15mm
Bolt
x4 x4
E: M8 x 20mm
Bolt
x4
B: M5 x 25mm
Bolt
x4
F: M8 x 35mm
Bolt
x4 x4
C: M6 x 15mm
Bolt
G: M8 x 50mm
Bolt
x4
D: M6 x 25mm
Bolt
x4
H: Washer
x4
I: Lag Bolt Washer
J: 5mm K: 10mm
x4
x2
N: M5 x 10mm Bolt
Required Tools
• 3/16” Wood drill bit
• 7/16” Masonry bit (for concrete installs)
• Socket set
• Phillips screwdriver
x2
O: Plastic CapM: Concrete Anchor
• Hammer (for concrete installs)
• Carpenter’s level
• Stud fi nder
L: Lag Bolt
x2
P: Quick-Lock TV Bracket
Supporting your digital lifestyle
™
3
Loading...