Kanto P101, P101W, P301 User Manual
English
User Manual
P101/P101W Projector Ceiling Mount
TILTING
22 lb
(10 kg)
EXTENDABLE
PROJECTOR
CEILING
MOUNT
3”-12”
(7.5 - 30cm)
20°
360°
Supporting your digital lifestyle
™
Table of Contents
Table of Contents / Introduction . . . . . . . . . . . . . 2
Supplied Parts & Hardware..................3
Setup - Step 1............................4
Setup - Steps 2 to 4 .......................5
Setup - Steps 5 to 7 .......................6
Other Kanto Products ......................7
Warranty ................................8
Introduction
Thank you for choosing a Kanto universal ceiling projector mount. The P101 and P101W are designed to mount TV
projectors weighing up to 22 lbs (10 kg). This mount kit allows for installations 3” (7.5 cm) from the ceiling, or 9” to 12”
(22.5 to 30cm) using the supplied extension tubes. The P101 and P101W provide a 360° swivel and a 20° tilt.
Read these instructions fully before installation of this mount. If you do not understand these directions, or have any
doubts about the safety of the installation, please consult a qualified installation contractor to install this mount. Make
sure there are no defective or missing parts. Do not use defective parts. If you are uncertain whether the part is defective
contact Kanto directly at 1-888-848-2643 or support@kantoliving.com. Kanto can not be liable for property damage or
injury caused by incorrect mounting, incorrect assembly, lifting or incorrect use of this product.
See installation video online at:
www.kantoliving.com
Visit our website at kantoliving.com for the most recent version of this manual
CAUTION
The maximum loading weight is 22 lbs (10 kg). This projector mount is intended for use up to the maximum
weight restrictions indicated. Use with products heavier than the maximum weights indicated may result in instability
causing possible injury.
CAUTION
The ceiling you plan to affix the Kanto mount to must be able to support more than 4 times the weight of
the projector and the ceiling mount combined. Do not use this product for any purpose other than to mount a
projector on a surface up to 20° from horizontal as outlined in this manual. Improper installation may cause damage
to your projector or serious injury. This product should not be mounted to drop ceilings, cinder block or old concrete
ceilings. Consult a qualified installation contractor if you are unsure about the type of ceiling you may have.
2
Supplied Parts and Hardware
Bolts:
M2.5 x 15mm (with washers)
A:
M3 x 15mm (with washers)
B:
M3 x 20mm (with washers)
C:
M4 x 15mm
D:
M4 x 20mm
E:
M4 x 25mm
F:
M5 x 15mm
G:
M5 x 20mm
H:
M5 x 25mm
I:
M6 x 15mm
J:
M6 x 20mm
K:
M6 x 25mm
L:
x4
each
Spacers:
Q:
1mm thick
R:
2mm thick
S:
4mm thick
T:
Base
x4
each
M: Allen Keys
O: Safety Screw
M5 x 10mm
x2
N: M8 x 55mm Bolt
(with nut)
x4x2
P: Set Screw
M5 x 5mm
U: Ceiling Plate
V: Projector Adapter W: Outer Extension
Tube
Z: Wrench
X: Inner Extension
Tube
Required Tools:
Crescent
Wrench
x2
x4
Y: Extension Brackets
75mm / 150mm
Phillips
Screwdriver
3
Supporting your digital lifestyle
™
Loading...