Kanto OASIS User Manual
User Manual
OASIS 50” TV Stand
Supporting your digital lifestyle
™
50” TV STAND FOR
37” TO 60” TELEVISIONS
English
37” - 60”
260 lbs
(118 kg)
Introduction
Table of Contents
Table of Contents / Introduction . . . . . . . . . . . . . 2
Supplied Parts & Hardware..................3
Setup - Step 1............................4
Setup - Step 2............................5
Setup - Step 3............................6
Setup - Steps 4 to 5 .......................7
Other Kanto Products ......................8
Warranty ................................8
2
Thank you for choosing a Kanto AV Systems TV stand. The Oasis 50” TV Stand will support 260 pounds (118 kg). It can be
used for any size TV, but is ideal for TVs from 37” to 60”. Easy to assemble, it features a vertically adjustable middle shelf
to accommodate AV components of different heights. Combine with a Kanto Stand Mount to mount your television and
gain flexibility and space.
Read these instructions fully before assembly of this stand. If you do not understand these directions, or have any doubts
about the safety of the installation, please contact Kanto AV Systems. Make sure there are no defective or missing parts.
Do not use defective parts. If you are uncertain whether the part is defective call Kanto AV Systems directly at 1-888-8482643 or email support@kantoav.com. Kanto AV Systems cannot be liable for property damage or injury caused by incorrect mounting, incorrect assembly, lifting or incorrect use of this product.
CAUTION
The maximum total loading weight is 260 lbs (118 kg). This TV stand is intended for use up to the maximum
weights indicated. Use with products heavier than the maximum weights indicated may result in instability causing
possible injury. Recommended TV Size: 37 inch to 60 inch.
See installation video online at:
www.kantoav.com/pages/video-oasis
Supporting your digital lifestyle
™
Supplied Parts and Hardware
3
• Phillips screwdriver
Required Tools
L: Middle and Bottom Glass (6mm)
H: Top Frame
D: 4mm Allen
Key
K: Top Glass (8mm)
E: Rounded
Wood Ends
F: Backing Board G: Rear Support
Frame
x2
x2
A: M6 x 32mm
Hex Head Bolt
x18
B: M4 x 15mm
Bolt
x6
C: 12mm
Rubber Bumper
x18
J: Bottom FrameI: Middle Frame
front view rear view
Loading...