Kanto L100 TV, L100 User Manual
User Manual
L100 TV Mount
Supporting your digital lifestyle
™
TILTING FLAT PANEL TV MOUNT
English
19” - 32”
56 lbs
(25 kg)
50 x 50
to
200 x 200
VESA
COMPLIANT
±12°
30°
Introduction
Table of Contents
Table of Contents / Introduction . . . . . . . . . . . . . 2
Supplied Parts & Hardware..................3
Setup - Step 1............................4
Setup - Step 2............................5
Setup - Steps 3 to 5 .......................6
Other Kanto Products ......................7
Warranty ................................8
2
Thank you for choosing a Kanto tilting wall mount. The L100 is designed to mount flat panel televisions weighing up to 56
lbs (25 kg) within 3” of your wall, allow you to swivel left and right approximately 30° (depending on TV size), and tilt your
TV ±12°.
Read these instructions fully before installation of this mount. If you do not understand these directions, or have any
doubts about the safety of the installation, please consult a qualified installation contractor to install this mount.
Make sure there are no defective or missing parts. Do not use defective parts. If there is hardware missing, or if you
are uncertain whether the part is defective call Kanto directly at 1-888-848-2643 or support@kantoliving.com. Kanto
cannot be liable for property damage or injury caused by incorrect mounting, incorrect assembly, lifting or incorrect
use of this product.
This product should not be mounted on steel stud walls or cinder block walls. Consult a qualified installation contractor if you are unsure about the type of wall you may have.
CAUTION
The wall you plan to affix the Kanto mount to must be able to support more than 5 times the weight of the
television and the wall mount combined. Do not use this product for any purpose other than to mount a flat panel
TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your TV or serious
injury. This product should not be mounted to steel stud walls, cinder block or old concrete walls. Consult a qualified
installation contractor if you are unsure about the type of wall you may have.
CAUTION
The maximum loading weight is 56 lbs (25 kg). This wall mount is intended for use only within the maximum
weight restrictions indicated. Use with products heavier than the maximum weights indicated may result in instability
causing possible injury. Recommended TV Size: 19 inch to 32 inch.
See installation video online at:
www.kantoliving.com/product/mount/l100#video
Supporting your digital lifestyle
™
Supplied Parts and Hardware
3
A: Wall Plate B: Arm Assembly C: TV Plate
E: M4 x 12mm
Bolt
D: Screw Cover
F: M4 x 30mm
Bolt
G: M6 x 12mm
Bolt
H: M6 x 35mm
Bolt
L: Lag Bolt
M: Concrete Anchor
x4 x4 x4
x4
J: M6 Washer
x6
K: Plastic Spacer
x4
x4
I: M4 Washer
x8
x4
N: Safety Knob
x2
O: Allen Bolt
x2
P: Spring Washer
x2
Q: Allen Key
Required Tools
Phillips
Screwdriver
Hammer (for
concrete
installs)
Pencil Stud
Finder
Level Drill
5/16”
Masonry
Bit
5/32”
Wood
Bit
Loading...