Kanto KT1937 User Manual
19” - 37”
40 lbs
(18 kg)
+15°
50x50
-
200x200
VESA
User Manual
KT1937 TV Mount
English
Supporting your digital lifestyle
™
TILTING FLAT PANEL TV MOUNT
Introduction
Table of Contents
Table of Contents / Introduction . . . . . . . . . . . . . 2
Supplied Parts & Hardware..................3
Setup - Step 1............................4
Setup - Step 2............................5
Setup - Steps 3 to 4 .......................6
Setup - Steps 5 to 6 .......................7
Other Kanto Products ......................8
Warranty ................................8
Thank you for choosing a Kanto tilting wall mount. The KT1937is designed to mount flat panel televisions weighing up to
40 lbs (18 kg) within less than 1.5” (35mm) of your wall. This mount will tilt your TV +15º.
Read these instructions fully before installation of this mount. If you do not understand these directions, or have any
doubts about the safety of the installation, please consult a qualified installation contractor to install this mount.
Make sure there are no defective or missing parts. Do not use defective parts. If there is hardware missing, or if you
are uncertain whether the part is defective call Kanto directly at 1-888-848-2643 or email support@kantoliving.com.
Kanto cannot be liable for property damage or injury caused by incorrect mounting, incorrect assembly, lifting or
incorrect use of this product.
This product should not be mounted on steel stud walls or cinder block walls. Consult a qualified installation contractor if you are unsure about the type of wall you may have.
CAUTION
The wall you plan to affix the Kanto mount to must be able to support more than 5 times the weight of the
television and the wall mount combined. Do not use this product for any purpose other than to mount a flat panel
TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your TV or serious
injury. This product should not be mounted to steel stud walls, cinder block or old concrete walls. Consult a qualified
installation contractor if you are unsure about the type of wall you may have.
CAUTION
The maximum loading weight is 40 lbs (18 kg). This wall mount is intended for use up to the maximum weight
restrictions indicated. Use with products heavier than the maximum weights indicated may result in instability causing
possible injury. Recommended TV Size: 19 inch to 37 inch.
See installation video online at:
www.kantoliving.com/product/mounts/KT1937#video
2
Supporting your digital lifestyle
™
Supplied Parts and Hardware
3
Wall Plate
N: Locking TV Bracket
x2
A: M4 x 15mm
Bolt
C: M5 x 15mm
Bolt
B: M4 x 25mm
Bolt
M: Washer
x4 x4 x4
J: Concrete Anchor
x4
K: 5mm
Plastic Spacer
x4
x4
I: Lag Bolt
x4
L: 14mm
Plastic Spacer
x4
D: M5 x 25mm
Bolt
x4
E: M6 x 15mm
Bolt
G: M8 x 15mm
Bolt
F: M6 x 25mm
Bolt
x4 x4 x4
H: M8 x 25mm
Bolt
x4
Required Tools
Socket
set
Phillips
Screwdriver
Hammer (for
concrete
installs)
Stud
Finder
Level Drill
3/8”
Masonry
Bit
5/32”
Wood
Bit
Pencil
Loading...