Kanto FMX2 User Manual

User Manual

FMX2 TV Mount

Supporting your digital lifestyle

™

FULL MOTION FLAT PANEL TV MOUNT

English

3.2–20”

(8.2–51 cm)

±80°

+14°/-8°

130 lbs

(59 kg)

75 x 75

to

800 x 450

VESA

COMPLIANT

Introduction

Table of Contents

Table of Contents / Introduction . . . . . . . . . . . . . 2

Supplied Parts & Hardware. . . . . . . . . . . . . . . . . . 3

Setup - Step 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Setup - Step 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Setup - Steps 3 to 4 . . . . . . . . . . . . . . . . . . . . . . . 6

Setup - Steps 5 to 6 . . . . . . . . . . . . . . . . . . . . . . . 7

Other Kanto Products . . . . . . . . . . . . . . . . . . . . . . 8

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

2

Thank you for choosing a Kanto full motion TV wall mount. The FMX2 is designed to mount fl at panel televisions weighing up
to 130 lbs (59 kg), extend up to 20” (51 cm) from your wall, allows you to swivel left and right 80°, and tilt your TV +14°/-8°.

You

can also adjust the horizontal level ±5°.

Read these instructions fully before installation of this mount. If you do not understand these directions, or have any
doubts about the safety of the installation, please consult a qualifi ed installation contractor to install this mount. Make
sure there are no defective or missing parts. Do not use defective parts. If there is hardware missing, or if you are
uncertain whether the part is defective call Kanto directly at 1-888-848-2643 or email [e-mail]. This
product should not be mounted on steel stud walls or cinder block walls. Consult a qualifi ed installation contractor if
you are unsure about the type of wall you may have

. Kanto cannot be liable for property damage or injury caused by

incorrect mounting, incorrect assembly, lifting or incorrect use of this product.

CAUTION

The wall you plan to affi x the Kanto mount to must be able to support more than 5 times the weight of the
television and the wall mount combined. Do not use this product for any purpose other than to mount a fl at panel
TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your TV or serious
injury. This product should not be mounted to steel stud walls, cinder block or old concrete walls. Consult a qualifi ed
installation contractor if you are unsure about the type of wall you may have.

CAUTION

The maximum loading weight is 130 lbs (59 kg). This wall mount is intended for use up to the maximum weight
restrictions indicated. Use with products heavier than the maximum weights indicated may result in instability causing
possible injury.

Visit our Website for the most recent version of this manual.

See installation video online at:
Regarder la video d’installation en ligne à:
Vea el vídeo de instalación online en:

www.kantomounts.com

Supporting your digital lifestyle

™

3

Supplied Parts and Hardware

Wall Plate

M: Lag Bolt

P: TV BracketN: Concrete Anchor

L: M8 Washer /

Lag Bolt Washer

x10

x6

K: M5/M6 Washer

x4

x6 x2

D: M6 x 35mm

Bolt

G: M8 x 50mm

Bolt

x4

x4

A: M5 x 12mm

Bolt

C: M6 x 12mm

Bolt

B: M5 x 30mm

Bolt

E: M8 x 20mm

Bolt

x4 x4 x4 x4

x4 x8

H: M5/M6

14mm Plastic Spacer

I: M5/M6/M8

10mm Plastic Spacer

O: Allen Key

x4

J: M5/M6/M8

5mm Plastic Spacer

Required Tools

Socket

set

Phillips

Screwdriver

Hammer (for

concrete

installs)

Crescent

Wrench

Stud

Finder

Level Drill

3/8”

Masonry

Bit

7/32”

Wood

Bit

F: M8 x 35mm

Bolt

x4