Kanto FMC4 User Manual

English

User Manual

FMC4 TV Mount

FULL MOTION FLAT PANEL TV MOUNT

100x100

100 lb

(45 kg)

-

600x400

VESA

±135°

Supporting your digital lifestyle

-5°/+10°

3.1” - 26”

(8 - 66 cm)

™

Table of Contents

Table of Contents / Introduction . . . . . . . . . . . . . 2

Supplied Parts & Hardware . . . . . . . . . . . . . . . . . 3

Setup - Step 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Setup - Step 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Setup - Steps 3 to 4 . . . . . . . . . . . . . . . . . . . . . . . . 6

Setup - Steps 5 to 6 . . . . . . . . . . . . . . . . . . . . . . . . 7

Other Kanto Products . . . . . . . . . . . . . . . . . . . . . . 8

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Introduction

Thank you for choosing a Kanto FMC4 full motion TV wall mount with adjustable pivot point. The FMC4 is designed
to mount fl at panel televisions weighing up to 100 lbs (45 kg), extend up to 26” from your wall, move your pivot point
from side to side up to 20”, pan left and right up to 135º (depending on TV size), and tilt your TV +10º / –5º.

Read these instructions fully before installation of this mount. If you do not understand these directions, or have
any doubts about the safety of the installation, please consult a qualifi ed installation contractor to install this mount.
Make sure there are no defective or missing parts. Do not use defective parts. If you are uncertain whether the part is
defective call Kanto Living directly at 1-888-848-2643 or [e-mail].

This product should not be mounted on steel stud walls or cinder block walls. Kanto cannot be liable for property
damage or injury caused by incorrect mounting, incorrect assembly, lifting or incorrect use of this product.

See installation video online at:
Regarder la video d’installation en ligne à:
Vea el vídeo de instalación online en:

www.kantomounts.com

Visit our website at kantoliving.com for the most recent version of this manual

CAUTION

The maximum loading weight is 100 lbs (45 kg). This wall mount is intended for use only with the
maximum weights indicated. Use with products heavier than the maximum weights indicated may result in
instability causing possible injury.

CAUTION

The wall you plan to affi x the Kanto mount to must be able to support more than 5 times the weight of the
television and the wall mount combined. Do not use this product for any purpose other than to mount a fl at
panel TV on a vertical surface as outlined in this manual. Improper installation may cause damage to your TV or
serious injury. This product should not be mounted to steel stud walls, cinder block or old concrete walls. Consult
a qualifi ed installation contractor if you are unsure about the type of wall you may have.

2

Supplied Parts and Hardware

Wall Plate

x4 x4

A: M5 x 15mm

Screw

x4

E: M8 x 20mm

Screw

x6

I: Lag Bolt Washer

B: M5 x 25mm

Screw

x4

F: M8 x 35mm

Screw

x8

J: 5mm Spacer

x4 x4

C: M6 x 15mm

Screw

x4

G: M8 x 50mm

Screw

x4

K: 10 mm Spacer

D: M6 x 25mm

Screw

x4

H: Washer

x6

L: Lag Bolt

x6

M: Concrete Anchor

N: 4mm Allen Key
O: 5mm Allen Key

P: 6mm Allen Key

Q: Quick-Lock

Bracket Arm

Required Tools

Socket

Set

3

Phillips

Screwdriver

Hammer (for

Concrete

installs)

Pencil

Stud

Finder

Level Drill

Supporting your digital lifestyle

R: Locking

Bracket Arm

7/16”

Masonry

Bit

3/16”

Wood

Bit

™