K and A Wireless EV4600 Users Manual

TABLE OF CONTENTS

Transmitter.......................................................................6

Transmitter Installation....................................................8

RF Exposure .................................................................... 9

TABLE OF CONTENTS .................................................. 2

SAFETY NOTICES ..........................................................3

PARTS LIST......................................................................5

PRODUCT DESCRIPTION.............................................5

EV-TX-4500 Installation Manual… 2

Specifications for the EV-TX-4600 SERIES.................10

SPECIFICATIONS ......................................................... 10

TROUBLESHOOTING..................................................12

.

PHONE [phone] FAX [phone] [e-mail]

2617 JUAN TABO BLVD. NE, SUITE A, ALBUQUERQUE, NM 87112

EYE-View™

EV-TX-4600

K&A Wireless, LLC

Toll Free [phone]

Albuquerque, NM 87112

2617 Juan Tabo Blvd, NE, Suite A

Owner’s Manual

Fax [phone]

Phone [phone]

http://www.ka-wireless.com

E-mail: [e-mail]

URL:

EYE-View™Transmitter

Made in USA

S/N: EV-TX-XXXXXX

FCC ID: OPH-EV4600

Model No: EV-TX-4600

FCC NOTICE

Additional installation instructions will be

provided to professional installers to insure

compliance with RF exposure requirements and

must be for occupational use only and cannot be

used in public applications.

EV-TX-4500 Installation Manual… 4

VI. This product must be professionally installed.

VII. The radio and its antenna is required to be

mounted and kept at least 20 cm away from any

part of the user’s torso or head and must not be

co-located or operating in conjunction with any

other antenna or transmitter.

PHONE [phone] FAX [phone] [e-mail]

2617 JUAN TABO BLVD. NE, SUITE A, ALBUQUERQUE, NM 87112

.

The equipment has been tested and found to comply with the

limits of a CLASS B device pursuant to PART 15 of the FCC

Rules. These limits are designed to provide reasonable

protection against harmful interference.

Emission designator for the EV-TX-4600 series transmitter

unit is: 16M5F3F.

The transmitter label is shown below. Please confirm that the

label on the transmitter is conforms to the label shown. Any

transmitters having a non-conforming label will be in violation

of the license.

Figure 1. FCC label on every EV-TX-4600 series unit.

SAFETY NOTICES

OPH-EV4600. Changes or modifications not

expressly approved by K&A Wireless, LLC will

void the user’s authority to operate the

occupational/controlled conditions, where users

have full knowledge of their exposure and can

exercise control over their exposure to meet FCC

limits. This device is not authorized for general

EXPORT USE ONLY. Equipment may be

operated only with a Part 90 license issued by the

FCC. The user is responsible for operating the

equipment in compliance with FCC rules.

Operation of this equipment without a valid FCC

license could result in the issuance of fines to the

user, or the seizure of the equipment.

EV-TX-4500 Installation Manual… 3

I. THIS DEVICE IS FOR PART 90 LICENSED OR

II. This product is intended for use in

population, consumer or any other use.

take into area where intrinsic safety is required.

III. This is NOT an intrinsically safe device. Do not

Bodily harm may result if warning is ignored.

IV. DURING INSTALLATION, DO NOT OPERATE

TRANSMITTER WITHOUT ANTENNA

CONNECTED TO ANTENNA PORT. Failure to

do so will result in damage to the unit and void the

warranty.

V. The transmitter is FCC approved under FCC ID:

equipment.

PHONE [phone] FAX [phone] [e-mail]

2617 JUAN TABO BLVD. NE, SUITE A, ALBUQUERQUE, NM 87112

.