Kambrook KFP10 Instruction Booklet

Instruction Booklet

Coffee & Herb

Mill

KFP10

Important

Please retain your instruction
book for future use.

In the event that you need some assistance with your
Kambrook appliance, please contact our Customer Service
Department on 1300 139 798 (Australia) or 0800 273845 (New
Zealand). Alternatively, visit us on our website at
www.kambrook.com.au or www.kambrook.co.nz

Contents

Kambrook Recommends p4
Safety First

Your Coffee and Herb Mill p6

Using Your Coffee and Herb Mill p7

Care, Cleaning and Storage p8

Recipes p9

Warranty p12

4

Kambrook Recommends Safety First

IMPORTANT: Please retain your
instruction book for future use.

At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer, can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.

Important Safeguards For Your Kambrook
Coffee and Herb Mill

• Carefully read all instructions before
operating and save for future reference.

• To protect against electric shock, do not
immerse the motor base, plug or cord in
water or any other liquid.

• Remove any promotional stickers or
packaging materials before using the
appliance for the first time.

• Always use the appliance on a dry,
level surface.

• Always switch the power off at the
power outlet and then remove the plug
when the appliance is not being used
and before cleaning.

• The grinder cannot be switched on until
the lid is in position.

• Do not use on a sink drain board.

• Do not use on an inclined surface.

• Do not place the appliance near
the edge of a bench or table during
operation. Always use on a dry,
level surface.

• Do not leave the appliance unattended
when in use.

• Do not move the grinder whilst
in operation.

• Do not place this appliance on or near
a hot gas or electric burner, or where it
could touch a heated oven.

• Do not use this appliance for anything
other than its intended use. Do not
use outdoors.

• Always disconnect the appliance
from the supply if it is left unattended
and before assembling, disassembling
or cleaning.

• Do not operate this appliance for
longer than 30 seconds as this could
cause overheating. Allow to cool for at
least 2 minutes after each use. Allow
appliance to cool down for 10-15
minutes after lengthy operation.

• Care shall be taken when handling
the sharp cutting blades, emptying the
appliance and during cleaning.

• Do not allow children to use the
appliance without supervision.

• Keep the appliance clean. Follow
the cleaning instructions provided in
this book.