Kambrook KFA213, KFA211, KFA210 User Manual

Arctic

Desk Fan

KFA210(23cm)/KFA211(30cm)
/KFA213(40cm)

Instruction Booklet

Contents

Kambrook Recommends p3
Safety First

Your Kambrook Arctic p5
Desk Fan

Using Your Kambrook p6
Arctic Desk Fan

Care and Maintenance p7

Warranty p8

Important

Please retain your instruction
book for future use.

In the event that you need some assistance with your
Kambrook appliance, please contact our Customer Service
Department on 1300 139 798 (Australia) or 09 271 3980 (New
Zealand). Alternatively, visit us on our website at
www.kambrook.com.au

Kambrook Recommends Safety First

IMPORTANT: Please retain your
instruction book for future use.

At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.

Important Safeguards For Your Kambrook
Arctic Desk Fan

• Carefully read all instructions before
operating the Kambrook Arctic Desk
Fan for the first time and save for
future reference.

• To protect against electric shock, do no
immerse the fan, cord or plug in water
or any other liquid

• This fan is intended for household
use only and not for commercial or
industrial use.

• Disconnect the power plug before
dismantling, assembling or before
cleaning and when the fan is not in use.

• Avoid touching mobile parts of the fan.

• Ensure the fan is on a dry and
even surface.

• Never insert fingers, pencils or any other
objects through the guards whenever
the power plug is connected, in
particular while the fan is switched on.

• The fan must not be used if the guards
are not fastened correctly, according
to these instructions.

• Do not operate in the presence of
explosives and/or flammable fumes
or liquids.

• Never leave the fan unattended when
in use.

• Do not unplug the fan by pulling on
the cord.

• Never carry the fan by the cord or yank
to disconnect from an outlet; instead,
grasp the cord and pull to disconnect.
Do not pull the cord around sharp
edges or corners.

3

Important Safeguards For All
Electrical Appliances

• Fully unwind the power cord before use.

• Do not let the power cord hang over
the edge of a bench or table, touch
hot surfaces or become knotted.

• To protect against electric shock do not
immerse the power cord, power plug or
housing in water or any other liquid.

• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.

• Children should be supervised
to ensure that they do not play with
the appliance.

• It is recommended to regularly inspect
the appliance. To avoid a hazard do
not use the appliance if power cord,
power plug or appliance becomes
damaged in any way. Return the
entire appliance to the nearest
authorised Kambrook Service Centre
for examination and/or repair.

• Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.

• This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors. Misuse may cause injury.

• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It
is advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice.

4

Your Kambrook Arctic Desk Fan

1. Fan blade size:

- KFA210 23cm

- KFA211 30cm

- KFA213 40cm

2. Choice of speed settings:

- KFA210 2 settings

- KFA211/KFA213 3 settings

3. 80° oscillation to disperse the air

throughout the room

4. Easy to use controller switch

(KFA210 only)

5. Easy twist controller switch (KFA211

and KFA213 only)

6. Tilt adjustable head to control the

direction of the air

7. Metal grille and plastic blades

8. Convenient carry handle for

easy portability

Parts List

9. Front grille with securing clips

and screw

10. Rear grille

11. Guard locking nut and blade cap

(KFA211 and KFA213 only)

12. Plastic fan blade

13. Motor head

14. Base

15. Three base screws (not shown)

5

Using Your Kambrook Arctic Desk Fan

Before First Use

Remove any promotional material from
the fan.

IMPORTANT: When
unpacking the fan, check to
see you have received
all the items listed in the
Parts List, before discarding
the packaging.

Assembling Your Arctic
Desk Fan

Base Assembly (KFA211 and
KFA213 Only)

1. Turn the motor head housing

upside down.

2. Locate the bottom of the housing

onto the base so that it sits securely
into place.

3. Using the 3 supplied base screws,

securely fasten the base to the motor
head housing.

Fan Head Assembly

1. Remove the Blade Cap (KFA211 and

KFA213 only) from the Motor shaft by
turning it clockwise, and then remove
the Guard Locking Nut by turning it
anti-clockwise.

2. Thread the Motor shaft through the

centre hole of the Rear Grille, placing
the Rear Grille into position. Make sure
that the carry handle, on the back of
the Rear Grille is located above the
motor housing. Ensure the Rear Grille
is aligned with the locating pins and
fix the grille into position by replacing
the Guard Locking Nut. Make sure that
the Rear Grille has not slipped off the
locating pins before tightening. This
should be done by hand. Do not force.

NOTE: When positioning the Rear
Grille on the Motor shaft, always
ensure the carry handle on the grille
is positioned in the upright position.

3. Insert the Plastic Blade onto the Motor

shaft, and match the pin slots in the
blade with the Motor shaft pin.

4. Fix the blade into place by tightening

the Blade Cap (KFA211 and KFA213
only) onto the Motor shaft in an anti­clockwise direction. This should be
done by hand. Do not force.

Fig. 1

NOTE: The KFA210 base is already

connected with the motor housing.

6

NOTE: Ensure the fan blade engages

fully onto the shaft. Please note this
may require some force to ensure it is
fully engaged.

5. Unlatch the Securing Clips on the

Front Grille and unscrew the small
screw located at the bottom of the
front guard.

6. Press together the Front and Rear

Grille, and secure by snapping shut
the Securing Clips over edges of both
grilles. Make sure that the small holes at
the bottom of both grilles are aligned.
Tighten the Securing Clips by hand.

7.

Thread the screw through the small
holes of both the front and back grilles,
and tighten using the nut provided.

Fig. 2

To Operate the Arctic
Desk Fan

Plug the cord into a 230V or 240V power
point and switch on.

NOTE: To avoid an electrical circuit
overload, it is recommended that no
other appliances are plugged into
the same circuit as your fan, when it
is in use.

Use the Controller Switch to select the
desired air flow speed setting.

0 – The fan is in the ‘OFF’ position
1 – Low
2 – Medium
3 – High

Setting the Oscillation

The oscillation function works in all air
flow settings.

Press down the Oscillation button to
activate. The fan will begin to oscillate
from side to side.

Lift the Oscillation button to stop the fan
from oscillating.

NOTE: The Oscillation button is
located behind the Rear Grille, on
the Motor head housing.

Adjustable Tilting Head

The Arctic Desk Fan incorporates
an Adjustable Tilt Head for greater
air coverage.

To adjust the angle of the head on the
KFA210, loosen the Control Knob located
beneath the Motor head housing, select
the required tilt angle, then tighten the
Control Knob.

To adjust the angle of the head on the
KFA211 and KFA213, while securely holding
the shaft of the fan body, simply lift or
lower the Motor head housing, the head
will click as it is being adjusted.

Care and Maintenance

Always switch the Arctic Desk Fan off,
prior to cleaning the housing, base, grilles
and blades.

To clean the outside of the fan, wipe the
exterior with a soft, damp cloth. Never use
an abrasive cleaner.

When not in use, store the fan (preferably
in its original box) in a cool, clean and
dry location.

(KFA210 only offers 2 settings)

Fig. 3

7

Kambrook 12 Month Replacement Warranty

In Australia, this Kambrook Replacement
Warrant y does not affect the ma ndatory
statutory rights implied under the Trade Practices
Act 1974 and other similar State and Territory
legislation relating to the applia nce. It applies
in addition to the conditions and warranties
implied by that legislation.

In New Zealand, this Kambrook Replacement
Warranty does not affect your mandatory
statutory rights implied under the Consumer
Guarantees Act 1993 in relation to the appliance.
It applies in addition to the conditions and
guarantees implied by that legislation.

This Kambrook Replacement Warranty is valid only
in the country of purchase, but other statutory
warranties may still apply.

This Warranty card and the purchase receipt
for this product are to be retained as proof of
purchase and must be presented if making
a claim under the Kambrook Replacement
Warranty. Please note that under any applicable
statutory warranty you are not required to
produce these documents, but may be required
to provide a proof of purchase.

Kambrook warrants the purchaser against defects
in workmanship and material for a period of 12
months domestic use from the date of purchase
(or 3 months commercial use).

Kambrook 12 Month Replacement Warranty

Your Purchase Record (Please Complete)

Date Of Purchase ________________________________

Model Number ___________________________________

The Kambrook Replacement Warranty does not
apply to any defect, deterioration, los s, injury or
damage occa sioned by, or as a res ult of, misuse
or abuse, neg ligent handling or if the product
has been used other than in accordance with
the instructions. The Kambrook Replacement
Warrant y excludes breakables such as glass and
ceramic items, consumable items and normal
wear and tear.

This Kambrook Replacement Warranty is void if
there is evidence of the product being tampered
with by unauthorised persons.

If the product includes one or a number of
accessories only the defective accessory or
product will be replaced. Subject to your statutory
rights, in the event of Kambrook choosing
to replace the appliance, the Kambrook
Replacement Warranty will expire at the original
date, i.e. 12 months from the original date of
purchase.

In the event that you need some assistance
with your Kambrook appliance, please contact
our Customer Service Department on 1300 139
798 (Australia) or 09 271 3980 (New Zealand).
Alternatively, visit us on the website at
www.kambrook.com.au

Attach a copy of the purchase receipt here.

Serial Number ____________________________________

Purchased From __________________________________

(Please don’t return purchase record
until you are making a claim)

Register your warranty at www.kambrook.com.au/service.asp

Kambrook - Australia
Building 2, Port Air Industrial Estate
1A Hale Street
Botany NSW 2019
Australia
Customer Service Line 1300 139 798
Customer Service Fax [phone]

Due to continual improvement in design or otherwise, the product you

purchase may differ slightly from the illustration in this book. Issue A10

Kambrook - New Zealand
Private Bag 94411
Botany, Manukau
Auckland 2141
New Zealand
Customer Service Line/Spare Parts

0800 273 845 or 09 271 3980
Customer Service Fax [phone]