KAM Transporter 300 Instruction Manual

Includes 2 x satellite speakers, 2 x speaker stands, mixer, media player, microphone and cables

5 channel audio mixer

2 band EQ per channel plus level

Individual reverb / FX level per channel

Reverb / digital delay / DSP effects

5 band equalizer with feedback monitor

Stereo (CD / tape) input with level control

Combi XLR / jack input sockets

Integral media player for SD and USB input

Dual speaker mount to include 35mm speaker stands

Power: 150W

Impedance: 4 Ohm

Power supply: 230V AC / 50Hz

MANUAL VERSION 1.0

11- 10- 11

For the latest instruction manual updates and information on the entire Kam range visit:

www.kam.co.uk

Kam products are manufactured by: Lamba plc, Unit 1, Southfields Road, Dunstable, Bedfordshire, United Kingdom LU6 3EJ

Telephone: (+44) (0)1582 690600 • Fax: (+44) (0)1582 690400 • Email: [e-mail] • Web: www.lambaplc.com

If this product is ever no longer functional plea se take it to a recycling plant for environme ntally friendly disposal.

Due to continuous product development, s pecifications and appearance are subject to change. © Copyright Lamba plc 2011. E&OE.

Transporter 300

Transportable PA system with built-in media player

Thank you for purchasing this Kam product, we are sure that it will serve you for many years to come.

To optimise the performance of this product, please read these operating instructions carefully to familiarise
yourself with the basic operations of this unit. Please retain them for future reference.This unit has been tested at
the factory before being shipped to you.

To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture. To prevent a fire
hazard, do not expose the unit to any naked flame sources. Unplug this apparatus during lightning storms or if it is
unlikely to be used for long periods of time.

When installing the unit, please ensure you leave enough space around the unit for ventilation. Slots and openings
in the unit are provided for ventilation to ensure reliable operation of the product and to protect it from overheating.
To prevent fire hazard, the openings should never be blocked or covered.

Always handle the power cable by the plug. Never pull out the plug by pulling on the cable. Never touch the power
cable when your hands are wet as this could cause an electric shock. Do not tie a knot in the cable. The power
cable should be placed such that it is not likely to be stepped on. A damaged power cable can cause a fire or give
you an electrical shock. Check the power cord periodicaly, if you ever find that it is damaged, replace it before
using the unit again. Contact your retailer for a replacement.

The voltage of the available power supply differs according to country or region. Be sure that the power supply
voltage of the area where this unit is to be used meets the required written on the unit.

The lightning flash symbol inside a triangle is to alert the user to the presence high voltage within the
unit’s enclosure that may be of sufficient power to constitute a risk of electrical shock to persons.

Caution: to prevent the risk of electric shock, do not attempt to open the unit. No user-serviceable parts
inside. Refer all servicing to qualified service personnel.

The exclamation mark inside a triangle is intended to alert the user to the presence of important operating
and maintenance instructions in the literature accompanying the appliance.

Select the installation location of your unit carefully. Avoid placing it in direct sunlight or locations subject to
vibration and excessive dust. Do not use the unit where there are extremes in temperature (below 41ºF / 5ºC or
exceeding 95ºF / 35ºC).

Unpacking and safety Please unpack your new product carefully. Your new product should reach you in perfect
condition. Please check that no damage has occurred during transit. If any damage is found, do not operate your
unit. Please contact the retailer you purchased it from immediately. If there is any damage to the mains cable do
not use the device. Always disconnect the unit from the mains supply when carrying out any cleaning of the unit.

What is included with the Kam Transporter 300

2 x speakers
2 x speaker cables
2 x speaker stands
1 x dynamic microphone
1 x microphone cable
2 x fuses Φ5 x 20mm T 3AL