KAM SOUNDPACK 1 Instruction Manual

SOUND PACK 1

instruction manual

Sound Pack 1

Sound Pack 1

SPECIFICATIONS

Kam is manufactured and Distributed by Lamba Plc

www.lambaplc.com

Specifications are subject to change without notice.

KKA100 Amplifier

Power 50W per channel
4 x unbalanced line level RCA audio inputs
2 x 1/4” Jack microphone inputs

Built in DSP echo effect

Speakers

Max power 80W

6.5” drivers
Soft dome tweeters
Max Sound Pressure Level 89dB

KAM SOUND PACK 1
Instruction Manual

OVERVIEW

Sound Pack 1 is the perfect home DJ/Karaoke monitoring solution. The

combination of amplifier, speakers, microphones and cables gives you
everything you need to add to a Karaoke enabled CD or DVD player to
get singing.

Sound Pack 1 should contain the following items;
1 x KKA100 Amplifier
2 x Speakers
2 x speaker cables
2 x Vocal Microphones
2 x XLR to 1/4” Jack Microphone cables

SETTING UP
You will find loads of useful tips and tricks about setting up and using
your equipment online at www.kam.co.uk/tuition.

1. Ensure that the Mains Power [1] is switched off and the Main Volume

[2] control is set at zero.

2. Use the supplied speaker cable to connect your speakers to the
KKA100 rear panel Speaker Terminals [3]. Follow the colour coding and
connect red to red and black to black.

3. Connect the audio out from your CD, DVD, Tape player or Mixer to the

Inputs [4] of the KKA100. You can connect any line level audio equipment,

but you can’t connect a turntable directly to the KKA100.

4. Turn on the Mains Power [1].

5. Select the music source you wish to listen to by turning the Input

Selector control [5].

6. Start your music playing.

7. Turn up the Main Volume control. Providing you have made all the
correct connections and used good cables your should hear music.

8. Use the Balance control [6] to adjust the proportion of sound distributed
to each speaker.

9. Use the Treble and Bass controls [7] to adjust the sound. Turning clock­wise will increase the amount of Bass or Treble and turning anti-clockwise
will decrease it.

USING YOUR MICROPHONES

10. If you are playing music, stop it whilst we set up the microphones.

11. Ensure that Mic1 & Mic2 Volume controls are set to zero.

12. Ensure that the Echo FX Level control is also set to zero.

13. Connect the XLR end of each supplied microphone cable to each
microphone. Connect the 1/4” Jack end of each microphone cable to Mic

Inputs 1 & 2 [10] on the front panel of the KKA100.

14. Slide the On/off Switch [11] of Mic1 to the ‘on’ position.

15. Sing into the microphone and slowly turn up the Mic1 Volume control.

16. Start your music playing and sing along... adjust the Mc Volume control
until you achieve a good balance between the volume of your music and
your voice.

17. Repeat steps 14 to 16 for Mic2.

18. Slowly turn up the Echo FX control until you set a pleasant balance
between the ‘wet’ sound of the Echo and the ‘dry’ sound of the microphone.

1

4

89

5

6 7

3

2

10

KAKA100 Front Panel

KAKA100 Rear Panel

- 1 - - 2 -

11