1
www.KALORIK.com
WFVC 43331 - 170120
WATER FILTRATION VACUUM CLEANER
ASPIRATEUR AVEC FILTRATION PAR EAU
WFVC 43331
EN……....4
SP..........14
FR….......25
120V~ 60Hz 1200 W (10A)
ASPIRADOR CON FILTRO DE AGUA
2
www.KALORIK.com
WFVC 43331 - 170120
PARTS DESCRIPTION
3
www.KALORIK.com
WFVC 43331 - 170120
PARTS DESCRIPTION
ENGLISH:
1. Dust brush
2. Crevice tool
3. Floor brush
4. Adjustable tube
5. Hook
6. Curved tube
7. Handle
8. Main body
9. Hose insert
10. Barrel
11. Base
12. Caster
13. Latch assembly
14. Filtration assembly
15. Power
16. Hose
SPANISH:
1. Cepillo de polvo
2. Boquilla para rincones
3. Cepillo de piso
4. tubo ajustable
5. Gancho
6. Tuvo curvado
7. Manilla
8. Cuerpo principal
9. Introducción de la manguera
10. Barril
11. Base
12. Ruedas
13. Conjunto de cerrojo
14. Conjunto de filtración
15. Encender
16. Manguera
FRENCH:
1. Brosse à poussière
2. Suceur plat
3. Brosse pour plancher
4. Tube télescopique
5. Crochet
6. Tube courbé
7. Poignée
8. Corps principal
9. Embout d’insertion du tuyau
10. Cuve
11. Base
12. Roue
13. Jeu d’attaches
14. Ensemble de filtration
15. Interrupteur d’alimentation
16. Tuyau
4
www.KALORIK.com
WFVC 43331 - 170120
IMPORTANT SAFEGUARDS
WARNING: To reduce the risk of fire, electric shock or injury, when using
your appliance, basic safety precautions should always be followed,
including the following:
1. READ ALL INSTRUCTIONS
2. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance or the adapter.
3. Do not leave the appliance unattended when plugged in. Unplug
from outlet when not in use and before servicing.
4. Do not use outdoors.
5. Do not allow to be used as a toy. Close attention is necessary when
used by or near children.
6. Please keep out of reach of children and pets. This product is not
intended for use by children, by persons with reduced physical,
sensory or mental capabilities, or lacking experience or knowledge,
unless they have been given supervision or instruction concerning
the use of the product, by a person responsible for their safety. Extra
caution is always necessary when using this product.
7. Use only as described in this manual. Use only manufacturer's
recommended attachments.
8. Never immerse the motor part in water or other liquids.
9. Do not use with damaged cord or plug. If appliance is not working
as it should, has been dropped, damaged or left outdoors, return it
to the service center of the manufacturer.
10. Do not abuse the cord. Never carry the base by the cord or yank to
disconnect from an outlet; instead grasp the plug and pull to
disconnect.
11. Keep the cord and the appliance away from heated or warm
surfaces. Do not pull cord around sharp edges or corners. Do not
close the door on the cord. Do not run appliance over cord.
12. Do not store in places exposed to direct sunlight. Store the
appliance only in a dry, cool place.
13. Do not handle plug or appliance with wet hands.
14. Use extra care when cleaning on stairs.
15. Do not use on uneven surfaces. Do not tip or tilt the unit over when
in use.
5
www.KALORIK.com
WFVC 43331 - 170120
16. Do not put any object into openings. Do not use with any opening
blocked; keep free of dust, lint, hair, and anything that may reduce
airflow.
17. Keep hair, loose clothing, fingers, and all parts of body away from
openings and moving parts.
18. Do not use without water in the tank.
19. Turn off the unit before unplugging.
20. Do not pick up anything that is burning or smoking, such as
cigarettes, matches, or hot ashes.
21. Do not use to pick up flammable or combustible liquids such as
gasoline or use in areas where they may be present.
22. Do not use to pick up liquids from containers, sinks, tubs, etc.
23. To avoid the risk of electrical shock, do not disassemble or attempt
to repair the vacuum. Incorrect re-assembly or repair can cause a
risk of electrical shock or injury to persons when the vacuum is used.
If needed, return the appliance to the nearest authorized service
facility for examination, repair, or adjustment.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug will fit into the polarized
outlet only one way. If the plug does not properly fit into the outlet at
first, reverse it. If it still does not fit, contact a competent qualified
electrician. Do not attempt to modify the plug in any way.
PARTS DESCRIPTION
See pages 2 & 3.
6
www.KALORIK.com
WFVC 43331 - 170120
UNPACKING AND ASSEMBLING
Step 1: Release the side latches and remove the main body (Fig. 1).
Step 2: Lift the filtration assembly and unpack the casters and
attachments from the barrel (Fig. 2).
Step 3: Insert the casters into the holes in the base, in a turning motion.
Then press down and make sure the casters are firmly attached (Fig. 3).
Step 4: Put down the filtration assembly (Fig. 4).
Step 5: Insert part 1 (on main body) into part 2 (of barrel). Then lock the
latches (Fig. 5).
7
www.KALORIK.com
WFVC 43331 - 170120
Step 6: Insert the hose insert into the barrel (for vacuuming function) or
in the “blower” hole (1) located in the main body (for blower function).
Gently rotate to the right to lock the hose in place and make sure it fits
tightly (Fig. 6).
Step 7: Insert the adjustable tube into the hook and set the tube in
place (Fig. 7). Fasten with the screw.
Step 8: Insert curved tube of the hose into the adjustable tube (Fig. 8).
Make sure the connection is tight.
Step 9: Insert the end of the extension tube into the floor brush (Fig. 9).
Make sure the brush is tightly attached to the tube.
USING YOUR VACUUM CLEANER
Assemble the vacuum cleaner before use.
ADD WATER TO THE BARREL BEFORE USE. Vacuuming without water
can damage the motor.
DO NOT operate the vacuum when water level is below the
“Working Level” line on the water tank.
8
www.KALORIK.com
WFVC 43331 - 170120
Use: The water filtration vacuum cleaner can be used on dry and wet
surfaces. To use as a wet pick-up vacuum, operate the unit on the wet
surface as you would for a dry surface.
WARNING: DO NOT overfill the water tank. The unit will stop working if
the tank is full. If full, turn off and unplug the unit. Then empty the tank
and clean. Refill with clean water at the “Working Level”, then plug unit
back in and continue working. DO NOT tip over.
On/Off Switch: Turn the unit on or off by pressing the power switch
located on top of the main body (Fig. 10).
Air Flow Control: Adjust the suction level by moving the pusher up or
down (Fig. 11).
Floor Brush: The floor brush can be used for hard floors and carpets. Use
the switch located on top of the brush to adjust the brush to the type of
floor you are cleaning. Lower the brush for bare floors, raise it for
carpets (Fig. 12).
Adjustable Tube: Adjust the tube to the desired length by pushing the
control switch. Release the button to lock (Fig. 13).
On/Off Switch
Fig. 10
Fig. 13
9
www.KALORIK.com
WFVC 43331 - 170120
Motor thermostat: The vacuum cleaner is equipped with a motor
protective thermostat. If the unit overheats, the thermal protector will
shut off the unit. Should this occur, turn off the vacuum cleaner and
unplug from the wall outlet. Allow the unit the cool before using again.
USING THE ACCESSORIES
Caution: Never attach or detach tools while the vacuum cleaner is
running. Turn off and unplug the vacuum before attaching accessories.
Using the crevice tool:
Use the crevice nozzle to clean narrow, hard-to-reach places, such
as heater gaps, wall ends and corners, etc.
When using the crevice tool, remove the floor brush and insert the
crevice tool directly into the extension tube.
Using the dust brush:
Use the dust brush to clean lamps, blinds, shelves, upholstery and
baseboards.
When using the dust brush, remove the floor brush and insert the
dust brush directly into the extension tube.
10
www.KALORIK.com
WFVC 43331 - 170120
CLEANING AND MAINTENANCE
Step 1: To empty the dirty water from your vacuum cleaner, release the
latches and remove the main body and filtration assembly (Fig. 14).
Note: Make sure to remove the hose before releasing the latches.
Step 2: Pour the dirty water in a bucket or in the toilet (Fig. 15). Then,
rinse under clear water.
Step 3: Remove the sponges from the filtration assembly and rinse them
under clean water (Fig. 16).
To clean the cyclone generator: Remove the cyclone generator from
the filtration assembly and rinse under clear water (Fig. 17).
To clean the filter: Remove the filter from the main body and rinse under
clear water. Let the filter air dry before putting back into place (Fig. 18).
11
www.KALORIK.com
WFVC 43331 - 170120
Notes:
Do not wash the filter in the dishwasher or in the washing machine.
Do not use a hair dryer to dry the filter.
Always make sure the filter is in place before operating the
appliance. Never use without the filter.
The filter should be cleaned twice a year. If visibly dirty, clean it at
once. Replace the filter if damaged.
To replace the filters, please follow instructions provided in the
separate installation guide.
STORAGE: Wrap the power cord around the main body. Insert the hook
of the adjustable tube into the side of the main body. Then, insert the
dust brush and crevice tool into the base (Fig. 19).
TROUBLESHOOTING
ISSUE
POSSIBLE REASON
POSSIBLE SOLUTION
The vacuum
cleaner
won’t run.
1. Switch button is not
on.
2. Power cord is not
firmly plugged into
the outlet.
3. Thermal protector is
activated.
4. There is too much
water in the barrel.
1. Turn the switch button
On.
2. Check that the plug is
inserted firmly into the
electrical outlet.
3. Allow cleaner to cool.
4. Remove some of the
water.
Suction is
reduced
1. The hose or tube is
clogged.
2. Filter is clogged.
3. Floor brush is
clogged.
1. Clean tube and/or hose.
2. Clean the filter.
3. Check floor brush and
clean if necessary.
CAUTION
Do not pick up anything that is burning or smoking, such as
cigarettes, matches, or hot ashes.
Do not use to pick up flammable or combustible liquids such as
gasoline or use in areas where they may be present.
Loading...