When using your appliance, basic safety precautions should always
be followed, including the following:
1. READ ALL INSTRUCTIONS carefully before using your appliance.
2. Do not operate the motor without melted chocolate in the bowl.
The chocolate acts like a lubricant for the auger and upper part.
If the motor is switched on without the chocolate, this could
damage the unit.
3. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
4. Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
5. To protect against electric shock, do not immerse cord, plug or
any part of the motor base in water or other liquids. Do not place
the motor base in the dishwasher.
6. Never place anything else than the intended ingredients in the
base bowl.
7. Close supervision is necessary when used by or near children or
infirm persons.
8. Do not leave unit unattended while in use or when plugged into
an outlet.
9. Unplug from the outlet when not in use, before removing or fixing
parts and before cleaning.
10. Do not operate the appliance with a damaged cord or plug, or
after the appliance has been damaged in any manner. If the
supply cord or appliance is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
11. The use of attachments that are not recommended or sold by
manufacturer may cause, fire electric shock or injury.
12. Do not use outdoors.
13. Never place the appliance on or near a hot surface.
2
USK CHM 1 - 060327
14. To reduce the risk resulting of becoming entangled or tripping
over a long cord a short power supply cord is provided.
15. 1Do not let the cord hang over edge of a table or counter or
touch hot surfaces.
16. Do not use this product for anything other than its intended use.
This appliance is for household use only and the appliance should
not be used for purposes other than stated in the instructions
accompanying this appliance.
17. Avoid contacting moving parts.
18. Do not handle the auger when in motion.
19. Do not assemble the auger or tower while the motor is running.
Turn the unit OFF first and unplug from the outlet while assembling
pieces.
20. Unplug from outlet when not in use and before removing parts for
cleaning.
21. Never use an abrasive sponge or cloth on unit.
22. The marked electrical rating of an extension cord should be at
least as great as the electrical rating of the appliance. Electrical
extension cords can be used if care is exercised in their use
23. Keep hands and foreign objects out of the fountain while
operating. Check regularly for large chunks of fruit, etc. Falling
into the base bowl. These will clog the base of the tower.
Chocolate will not flow properly.
24. To operate properly, the unit must be on a flat, level surface.
SAVE THESE INSTRUCTIONS
POLARIZED PLUG INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the
other). To reduce the risk of electric shock, this plug will fit into the
polarized outlet only one way. If the plug does not properly fit into
the outlet at first, reverse it. If it still does not fit, contact a competent
qualified electrician. Do not attempt to modify the plug in any way.
3
USK CHM 1 - 060327
SHORT CORD INSTRUCTIONS
A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.
• The electrical rating of the extension cord should be at least that
of the appliance. If the electrical rating of the extension cord is
too low, it could overheat and burn.
• The resulting extended cord should be arranged so that it will not
drape over the counter top or tabletop where it can be pulled
on by children or tripped over.
PARTS
6
2
3
1
4
1. Motor switch
2. Bowl
3. Pilot light
4. Heater switch
5. Height adjusting screw
6. Tower
7. Auger
4
7
5
USK CHM 1 - 060327
This fountain can be used with a variety of chocolates or sauces.
Depending on your taste, you can use milk chocolate, dark
chocolate, white chocolate, butterscotch to dip fruit pieces,
marshmallows, cookies etc.
BEFORE THE FIRST USE
• Remove all packaging material and wipe out the base bowl with
a damp cloth and dry. Make sure no water penetrates in the
motor unit.
• Clean the auger and the tower with soapy water, rinse and dry
thoroughly.
ASSEMBLY
Make sure all switches are in OFF position and that the appliance is
unplugged before assembling.
Never attempt to place the auger or the tower on the base while the
motor is running.
To assemble the appliance, put the auger on the axle in the center
of the bowl, and pass the tower over the auger, making sure that the
three openings on the bottom of the tower fit in the three pins in the
center of the bowl.
To work properly, the surface must be level. If it is not totally level, you
can adjust the position of the appliance by turning the height
adjusting screw in the adequate direction.
HOW TO USE
• Once the appliance is correctly assembled, plug it into a wall
socket.
• To start, turn the right switch (4) to activate the heater. The pilot
light goes on, indicating that the appliance is heating.
• Let the unit warm up for at least 3 to 5 minutes before adding the
melted chocolate.
• In the meantime, prepare the chocolate as follows:
Combine 1.7lbs of chocolate chips with 1 cup of cooking oil in a
microwave safe bowl. Place bowl in microwave, and heat for 2
5
USK CHM 1 - 060327
minutes. Remove and stir chocolate, if chocolate is not completely
melted after stirring, cook for an additional 2 minutes or until
chocolate is completely melted.
The chocolate needs to be completely melted and must be of a thin
consistency before pouring into the fountain. This will allow proper
flow of the chocolate. To check the consistency of the chocolate,
dip a large spoon into the chocolate. The chocolate should flow
smoothly off the back of the spoon. If the chocolate too thick, add
more oil.
CAUTION: chocolate burns very easily; keep an eye on the
chocolate when melting.
Never add cold or cool liquids to the melted chocolate in the
fountain. This will disrupt and stop the flow of chocolate.
• Once the chocolate is completely melted and is of the proper
consistency, pour it into the bowl located at the base of the
tower.
• Then turn the motor switch to the ON position. The motor and the
heater should now be running at the same time.
• The melted chocolate will be drawn under the tower and pulled
up by the auger through the tower tier. The chocolate will then
begin to flow to the top of the tower tier and flow evenly over the
sides of each tier.
• You can now immerge fruit pieces, marshmallows or cookies in
the chocolate flow to coat them with melted chocolate.
•IMPORTANT: The unit must be level in order for the chocolate to
flow evenly and properly. Check the fountain consistently so as to
avoid food pieces falling into the chocolate. Food pieces will
stop the flow of chocolate.
• To extend the life of the unit be sure to properly follow all
cleaning instructions after every use. Make sure the chocolate is
flushed from the tower tier while washing the fountain to avoid
chocolate build up. Do not apply cleansing abrasives to the
fountain or use an abrasive cloth, sponge, scouring pad, or the
like on the fountain.
6
USK CHM 1 - 060327
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.