Kalorik JK 39825 User Manual



Fax [phone]

Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

Jug kettle

Hervidor

Bouilloire

JK 39825

www.KALORIK.com



Front cover page (first page)

Assembly page 1/24

120V~ 1500W



Fax [phone]

Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:

1. READ ALL INSTRUCTIONS

2. Check that the voltage in your home corresponds to what is
stated on the appliance.

3. Do not touch hot surfaces. Use handles or knobs.

4. To protect against electrical shock do not immerse cord, plugs, or
the jug kettle in water or other liquid.

5. Close supervision is necessary when any appliance is used by or
near children.

6. Unplug from outlet when not in use and before cleaning. Allow to
cool before putting on or taking off parts.

7. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the nearest authorized service
facility for examination, repair, or adjustment.

8. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.

9. Do not use outdoors.

10. Do not let cord hang over edge of table or counter, or touch hot
surfaces.

11. Do not place on or near a hot gas or electric burner, or in a
heated oven.

12. To connect, plug cord into the wall outlet. To disconnect, put the
switch in off position, then remove plug from wall outlet.

13. Do not use appliance for other than intended use.

14. Scalding may occur if the lid of the jug kettle is removed during
the heating cycles.

15. Make sure the appliance never comes into contact with
inflammable materials such as curtains, textiles, etc., when it is in
use, as they might catch fire.

16. When removing lime scale, only use special products for the
removal of lime scale. Never use ammonia or any other
substance that might damage your health.

2

Assembly page 2/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

17. Ensure that the kettle is properly located on the power base
before switching on.

18. Remove the kettle from power base before filling or pouring. Do
not attempt to remove the kettle from the power base until it is
switched off, manually or automatically.

19. Use the kettle only with the power base supplied and vice versa.

20. Use on a hard, flat level surface only.

21. Extreme caution must be used when handling or moving kettle
and pouring from the kettle when water has boiled.

22. The kettle shall only be used with the base provided.

23. Do NOT overfill, to avoid boiling water being ejected from the
kettle.

HOUSEHOLD USE ONLY

SAVE THESE INSTRUCTIONS

3-PRONG PLUG INSTRUCTIONS

For your personal safety, this appliance must be grounded. This
appliance is equipped with a power supply cord having a 3-prong
grounding plug. To minimize possible shock hazard, the cord must be
plugged into a mating 3-prong, grounding type, wall receptacle,
grounded in accordance with the National Electrical Code
ANSI/NFPA 70 latest edition and all local codes and ordinances. If a
mating wall receptacle is not available, it is the personal
responsibility and obligation of the customer to have a properly
grounded, 3-prong, wall receptacle installed by a qualified
electrician.

3

Assembly page 3/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

SHORT CORD INSTRUCTIONS

A short power supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.

• The extension cord should be a grounding type 3-wire cord.

• The electrical rating of the extension cord should be at least

that of the appliance. If the electrical rating of the extension
cord is too low, it could overheat and burn.

• The resulting extended cord should be arranged so that it will

not drape over the counter top or tabletop where it can be
pulled on by children or tripped over.

PART DESCRIPTION

6

1. Power base

2. Illuminated switch

3. Handle

5

4

3

2

1

4. Lid release button

5. Lid

6. Water level indicator

4

Assembly page 4/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.

OPERATION

• Always remove the jug from the power base before filling it or
before any operation.

• Raise the lid and fill the tank with fresh water paying attention not
to fill under the minimum mark or above the maximum mark in
the kettle.

• Release the lid and make sure it closes correctly.

• Put the jug onto the power base, plug into the wall socket and

switch on. The pilot light of the switch will come on, indicating
that the appliance is operating. If it does not come on, check if
the kettle is correctly positioned on the base and check if the
base is plugged in.

• The jug kettle will switch off automatically when the water has
boiled. However, you can stop the appliance any time by putting
the switch in the off position.

• For instant reboiling, wait until water has cooled down and switch
on the appliance again.

SAFETY CUT-OUT

• This jug kettle is protected with an automatic safety device if
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.

• In this case, switch off the appliance by putting the switch in OFF
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.

• The kettle may then be used as normal.

5

Assembly page 5/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

CLEANING AND MAINTENANCE

• Before attempting any cleaning operation, make sure the
appliance is unplugged from the supply socket and fully cooled
down.

• To clean the exterior surfaces, simply wipe over with a soft damp
cloth and dry thoroughly. Never use abrasive products

• On no account must the jug kettle or its power base be immersed
in water.

FILTER

• Your appliance is provided with a mesh filter. This filter is factory
pre-installed before the spout.

• The filter is placed in front of the spout. Filter should be rinsed
clean regularly. For this, slide the filter out, rinse under water, and
slide it back into position once clean.

DESCALING

To remove scale from the jug kettle, use products made especially
available for this purpose. Make sure to use a type recommended
for plastic kettles.

6

Assembly page 6/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

WARRANTY

We suggest that you complete and return the enclosed Product
Registration Card promptly to facilitate verification of the date of
original purchase. However, return of the Product Registration Card is
not a condition of these warranties. You can also fill out this warranty
card online, at the following address: www.KALORIK.com

This KALORIK product is warranted in the U.S.A. for 1 year from the
date of purchase against defects in material and workmanship. This
warranty is not transferable. Keep the original sales receipt. Proof of
purchase is required to obtain warranty performance.

During this period, if the KALORIK product, upon inspection by
KALORIK, is proven defective, it will be repaired or replaced, at
Kalorik’s option, without charge to the customer. If a replacement
product is sent, it will carry the remaining warranty of the original
product.

This warranty does not apply to any defect arising from a buyer's or
user's misuse of the product, negligence, failure to follow KALORIK
instructions noted in the user’s manual, use on current or voltage
other than that stamped on the product, wear and tear, alteration
or repair not authorized by KALORIK, or use for commercial purposes.
There is no warranty for glass parts, glass containers, filter basket,
blades and agitators, and accessories in general. There is also no
warranty for parts lost by the user.

ANY WARRANTY OF MERCHANTABILITY OR FITNESS WITH RESPECT TO
THIS PRODUCT IS ALSO LIMITED TO THE ONE YEAR LIMITED WARRANTY
PERIOD.

Some states do not allow limitation on how long an implied warranty
lasts or do not allow the exclusion of incidental or consequential
damages, so the above limitations may not apply to you. This
warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.

7

Assembly page 7/24

USK JK 39825 - 120501



Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good

Fax [phone]

numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only

what is inside the frame,

If the appliance should become defective within the warranty
period and more than 30 days after date of purchase, do not return
the appliance to the store: often, our Customer Service
Representatives can help solve the problem without having the
product serviced. If servicing is needed, a Representative can
confirm whether the product is under warranty and direct you to the
nearest service location.

If this is the case, bring the product, or send it, postage prepaid by
the user (all Kalorik customers are responsible for the initial shipment
back to the warranty center), along with proof of purchase and a
return authorization number indicated on the outer package, given
by our Customer Service Representatives. Send to the authorized
KALORIK Service Center (please visit our website at
www.KALORIK.com or call our Customer Service Department for the
address of our authorized KALORIK Service Center).
When sending the product, please include a letter explaining the
nature of the claimed defect.

If you have additional questions, please call our Customer Service
Department (please see below for complete contact information),
Monday through Thursday from 9:00am - 5:00pm (EST) and Friday
from 9:00am - 4:00pm (EST). Please note hours are subject to change.

If you would like to write, please send your letter to:

KALORIK Customer Service Department

Team International Group of America Inc.
1400 N.W 159th Street, Suite 102
Miami Gardens, FL 33169 USA

Or call:

Toll Free: +1 888-521-TEAM / +1 888-KALORIK

Only letters can be accepted at this address above. Shipments and
packages that do not have a return authorization number will be
refused.

8

Assembly page 8/24

USK JK 39825 - 120501