Kallista P34402, P34401 Installation Manual

5/16"1/8"

Record your model number below
for future reference:

Single-Post Accessories:

2

Position the wall plate and mark the
holes. Verify plumb.

CAUTION: Risk of personal
injury.

Do not install where the product might
be used as a grab or support bar.

Drywall Into Studs:

3

Drill 1/8" holes. Secure the wall
plate(s).

Important Information

These products should be located and
mounted to a wall stud. While it is
possible to mount them to any surface,
a stud-mounted product will yield the
best results.

Between Studs Or Into Tile:

Drill 5/16" holes. Insert the anchors.
Secure the wall plate(s).

Recommended Tissue Holder
Location

8" (203 mm) –
12" (305 mm)

6"
(152 mm)

For All Accessories:

4

Position the accessory onto the wall
plate(s). Tighten the setscrew(s).

Verify “X” against the measurements of
your product model.

X

P34401: 24" (610 mm)
P34402: 18" (457 mm)

For All Installations:

1

Loosen the setscrew and remove the
wall plate from the accessory.

1314842-2-A

Questions? Problems? For additional assistance, please contact KALLISTA's
Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or
kallista.com.

1314842-2-A © 2017 KALLISTA