Kallista P23065, P23071 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

Pulldown Kitchen Faucet

P23071P23065

1072005-2-B
Page 1 of 4

Questions? Problems? For additional assistance, please contact Kallista’s Customer

Questions? Problems? For additional assistance, please contact Kallista’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

Pulldown Kitchen Faucet

Ring

Screw

Metal Washer

Fiber Washer

Sink

Faucet

Supply Hose

Shank

INSTALLATION INSTRUCTIONS

THANK YOU FOR CHOOSING KALLISTA

We appreciate your commitment to Kallista quality products. Please take a moment to review this manual
before you install your Kallista product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.

BEFORE YOU BEGIN

CAUTION: Risk of fresh water contamination. This faucet contains important back-siphonage

protection. Do not replace the faucet ground joints or remove any components.

Observe all local plumbing and building codes. 
Shut off the water supplies. 
Carefully inspect waste and supply tubing for any sign of damage and replace if necessary. 
For new installations, assemble the faucet on the sink before installing the sink. 
Except for plumbers putty, do not use petroleum based products on this faucet. 
Before installation, unpack the new faucet and inspect it for damage. Return the faucet to the carton until 

you are ready to install it.
Kallista Co. reserves right to make revisions in the design of faucets without notice, as specied in the 

Price Book.

TOOLS AND MATERIALS

Hex

Wrench

Phillips�

Screwdriver

Adjustable

Wrench

1. FAUCET INSTALLATION

Ensure that O-ring is installed in bottom of escutcheon. 
Partially thread the two screws into the threaded ring until 

the screws barely protrude from the backside of the thread­ed ring.

Fit the faucet through the hole in the sink. Position the fau- 
cet so the handle faces in the desired position. The recom­mended handle position is to the user’s right.

Turn the ring so the screws are to the front and back. 
Use a Phillips screwdriver to tighten the screws securely 

and evenly.

Two 3/8” Male�

Supply Connections

Plumbers

Putty

1072005-2-B
Page 2 of 4

Questions? Problems? For additional assistance, please contact Kallista’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].