Kallista One P23080 Installation Instructions Manual

Questions? Problems? For additional assistance, please contact Kallista's Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

INSTALLATION INSTRUCTIONS

1072018-2-B
Page 1 of 3

P23080

One™ Wall Mount Pot Filler

THANK YOU FOR CHOOSING KALLISTA

BEFORE YOU BEGIN

TOOLS AND MATERIALS

1. PREPARE THE SITE

We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before
you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.

Adjustable

Wrench

Silicone
Sealant

Hex

Wrench

Thread

Sealant

Strap

Wrench

Level

Observe all local plumbing and building codes.

Shut off the main water supply.

Carefully inspect waste and supply tubing for any sign of damage.

Replace waste or supply tubing if necessary.

Do not use petroleum based products in this project; the only exception being the sealant; between the wall

and the back flange.

Kallista reserves the right to make revisions in the design of faucets without notice, as specified within the
Price Book.

IMPORTANT! The supply should not extend farther than 1/2” (1.3 cm)

beyond the finished wall material.

Determine the faucet installation location.

Install a supply stop and route the water supply to the installation
location.

Install appropriate backing and secure the supply pipes so the
front face of the pipe nipple will protrude no more than 1/2” (1.3 cm)
beyond the finished wall surface.

Install the wall board and finished wall material. Allow a 1-3/16” (3
cm) diameter opening in the wall board and finished wall material for

the faucet supply connection.

Tile

Supply

1-3/16”

(3 cm)

1/2” NPT

Male Pipe Thread

1/2” (1.3 cm)

Max

Questions? Problems? For additional assistance, please contact Kallista's Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

INSTALLATION INSTRUCTIONS

1072018-2-B
Page 2 of 3

P23080

One™ Wall Mount Pot Filler

2. INSTALL THE FAUCET ASSEMBLY

Finished Wall

Supply

Mounting Plate

Screw

Set Screw

Anchor

Escutcheon

Shank

Spout

Small

Set Screw

Slide the mounting plate on to the faucet shank.

Align the groove in the underside of the faucet shank with the set screw hole in the mounting plate and
secure with the set screw.

Temporarily install the faucet onto the supply until the mounting plate is both flush with the wall and the set
screw is facing down.

With a pencil, mark the location of the four mounting holes.

Remove the faucet from the supply.

Remove the mounting plate from the faucet shank.

Drill a 1/4” hole at each of the four marked locations.

Install an anchor into each of the four holes.

Apply thread sealant to the supply pipe threads.

Slide the mounting plate over the supply and up against the finished wall. Position the mounting plate so
the set screw hole is facing down.

Line up the holes in the mounting plate with the anchors and secure with the four screws.