Kallista L20306, L20308, L20307, L20309, P72080 Installation Manual

INSTALLATION INSTRUCTIONS

Single Basin Stainless Steel Sink

L20306

L20308

L20307, L20309

P72080

1154432-2_#1827948_B
1 of 8

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

Single Basin Stainless Steel Sink

INSTALLATION INSTRUCTIONS

THANK YOU FOR CHOOSING KALLISTA

We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.

BEFORE YOU BEGIN

WARNING: Risk of personal injury. Use gloves and handle sink edges carefully. Metal surfaces are

sharp and can cause severe cuts.

 Please read all instructions before you begin.
 Observe all local plumbing and building codes.
 Shut off the main water supply.
 The appearance of your product may differ from what is shown in these instructions, however, the

installation procedure is the same.

 This guide contains two installation methods. Carefully read this entire instruction manual before beginning

the installation to determine the appropriate method for your installation.

 Measure the cabinet opening where the sink will be installed. Plan for adequate clearance between the

faucet handles and the backsplash or nished wall.

 The number of clips included with your sink may differ from the number of clips illustrated. Use all clips

included with the sink.

 Countertop manufacturer/installer should install the anchors into the underside of the countertop. Use the

anchors and fasteners provided by the countertop manufacturer and the clamps provided with your sink.
 Clean the underside of the countertop at the sink installation area thoroughly before installing the sink.
 Allow the sealant to cure following the sealant manufacturer’s instructions.
 KALLISTA reserves the right to make revisions in the design of products without notice, as specied in the

Price Book.

1154432-2_#1827948_B
2 of 8

TOOLS AND MATERIALS

Clear 100% Silicone

Sealant or Caulk

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].

Plus

• Conventional woodworking
tools and materials, as
appropriate

• Saw

• Screws

• Screwdriver

INSTALLATION INSTRUCTIONS

1. PREPARATION (WOOD FRAME INSTALLATION)

Single Basin Stainless Steel Sink

Apply silicone sealant.

Wood Frame

Clearance for the Sink Basin

 Verify cabinet clearance.
 Construct a wood frame for the inside of the cabinet. Allow adequate clearance for the faucet valving and

sink basin. Ensure the frame will support the entire sink rim.

IMPORTANT! For the larger sinks, install the frame only on the front and sides of the sink at this time.

IMPORTANT! The frame should be located so that once the sink is installed, the top of the sink rim will be ush

with the top of the cabinet walls.

 Position the wood frame within the cabinet and secure. Locate the fasteners for easy access in case the

sink needs to be removed.

 Apply a 1″ (2.5 cm) bead of sealant at each corner of the wood frame where it will contact the sink.

1154432-2_#1827948_B
3 of 8

Questions? Problems? For additional assistance, please contact KALLISTA’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].