1
Instruction Manual
For Electric Convection Heater
Please read it carefully before use and save these important safeguards
Features:
l. Comfortable and noiseless.
2. Smooth appearance, safe for family use.
3. Unique appearance, novel style.
4. With thermostat, convenient for controlling the room temperature.
5. With thermal cut-off to avoid over-heating.
Views of the appliance and part name:
1. Front cover
2. Grille
3.Temperature regulator
4. Power switch
5. Wall mounted bracket
6. Rear cover
7. Foot
..
.
Models of the appliance and main technology specifications:
Model
Power Regulation
Range (W)
Suitable Area (m2)
EKO 500
230V~500
12-14
EKO 1000
230V~1000
15-18
EKO 1500
230V~1500
18-22
EKO 2000
230V~2000
22-26
Remarks: 1. Refer to the label on the appliance for the power supply.
2. The suitable area is only for your reference.
Floor standing:
1
2
3 4 6 5 7
2
1. Put the heater upside down, fix the foot the bottom of the heater, make sure
the screw holes are matched correctly, then tighten up the screw.
2. Stand up the heater.
Mounting on the wall:
1. Fix bracket(c) to the wall using the plugs and screws provided.
2. Position to allow a minimum of 50cm clearance from the base of the
produce to the floor and 50cm clearance from the top of product to the
ceiling，ensure that it is positioned at least 1m from soft furnishings and
curtains. According to the holes position on the bracket, Mark the holes
position where the bracket will be fixed on the wall. Drill the holes on your
wall according to you marked, make sure the diameter of the holes is
suitable for screw. Insert the screw and fix the bracket, Place the heater on
the bracket and lock it via the locking sheet. Fix the locking sheet and
bracket with the M4×8 screw between.
B
A
DC
>50cm
>50cm
Lock sheet
M4×8 Screw
Instruction:
1. The thermostat switch On the thermostat switch there is “L”(low )
H” (high) printing, rotate the
switch, as arrow pointed
① ”Low” The lowest setting temperature(Remark :when surroundings
temperature is not below 0℃ ,the thermostat is disconnect condition.)
② :High”: The highest setting temperature.
Remark: With this switch you rotate the thermostat switch from “L” to “H”,
the thermostat operate once heard a sound like “click” ,turn the switch to
your desired temperature control condition.
2. The power switching knob on the power switching knob , there are printed
, rotate the switch, as arrow pointed
a “ ” : the device is turned off
b " ” : anti-frozen mode
c “ ”: economical mode
Loading...