Page 1
QUICK START
Pocket Charge 6K
Charge your phone,
tablet or usb device
Page 2
Safety Precautions
Before using the Pocket Charge 6K, please ensure
you read and understand all the safety precautions
below.
Keep the Pocket Charge 6K away from water
and other liquids. Do not use the Pocket Charge
6K with wet hands as this may cause the unit to
malfunction.
Keep the Pocket Charge 6K away from direct
sunlight and heat sources.
The Pocket Charge 6K may become slightly warm
during use. This does not indicate a malfunction.
Do not place heavy objects on the Pocket Charge
6K, as this may cause the unit to malfunction.
Do not attempt to open the case or modify the
Pocket Charge 6K in any way, as this will void your
warranty.
Maintenance and repairs should only be performed
by Kaiser Baas.
Do not dispose of the unit via conventional
domestic waste.
Your device may become warm while charging.
Specifications
Capacity: 6000mAh
Output: 5V/1000mA
Input: 5V/1000mA
Dimensions: 94x45x23.9mm
Charging Time: 6.5hours (Using 1A AC Adapter)
Operation Temperature: -5°C ~ +55°C
Cycle Life: 500 Cycles
Page 3
Product Diagram
1
Switch ON/OFF
3
Torch Light
2
1A Output
4
Micro USB Input
Port
1A OUT
IN
1
2 3
4
Charge Indicator
5
One LED On - Power <25%
6
Two LED On - Power 25 -50%
7
Three LED On - Power 50 - 75%
8
Four LED On - Power <75-100%
1
5678
Page 4
Using the Pocket Charge
6K
Please charge the Pocket Charge 6K to full capacity
before your first use.
To charge your digital
device
Connect the output port
2
of your Pocket Charge
6K to your device via a usb cable.
Press the On/O switch one time to start charging
your device.
The LED Indicators should turn on.
Tip: Refer to the previous page for information on the charge
status
When charging a device you can toggle the LED
Indicators by pressing the On/O Switch. You
cannot turn o the powerbank whilst it is charging.
Sleep Mode:
When the LED Indicators are o but your device is
charging this mode is called Sleep Mode.
To stop Charging simply disconnect your device
from the powerbank. The Powerbank will
automatically cut output within 1min.
Please note only a Micro USB to USB cable is
supplied.
LED Torch
To activate the Torch press and hold the On/O
Switch
1
for 3 Seconds to turn on.
To deactivate the Torch press and hold the On/O
Switch
1
for 3 seconds to turn o.
Page 5
Charging the Pocket
Charge 6K
The Pocket Charge 6K has 2 methods to recharge:
Recommended Method:
Connect the Pocket Charge 6K via the Micro USB
Input Port to a 1A AC Wall Adapter with USB
(Please Note this is not supplied).
Alternative Method:
Connect the Pocket Charge 6K via the Micro USB
Input Port to a
USB Port on a PC or Laptop.
When recharging the four LED indicators will flash
one by one.
Pressing the On/O Switch whilst charging will
enable sleep mode. This keeps the Pocket Charge
6K charging.
Charging Time
The charging time will depend on the output power
of the AC wall adapter.
If using a 1A Wall Adapter it will need at least
6.5hours to fully charge.
Note: Please recharge the Pocket Charge 6K every
3 months if it is not being used regularly.
Page 6
Troubleshooting
Problems Possible
Causes
Corrective
Actions
Unit has been
charg ing for
long time but
indicators
dont show full
capacity
1. Charging
time is not
enough
2. Adapter
output current
is too low
1. Ensure it has
been charging
for at least
6.5hours
2. Use the
original cable
and a certified
AC adapter
The Pocket
Charge 6K
can not fully
charge other
devices.
1. No power
or low power
left.
2. Failed input
cable and
connectors, or
connector is
incorrect.
1. Charge it
again.
2. Use another
output cable
and connector
or the orginal
device cable.
Pocket Charge
6K could not
charge device,
continuosly, or
intermittenly
charges
devices. Two
beeps may
happen.
1. Failed cable
or connector.
2. Low power
left.
3. Device may
need higher
input voltage
than available.
1. Use
another cable
or check
connector.
2. Charge it
again.
3. Please
don’t use the
device when
charging nor
charge your
device when it
has remaining
charge.
Page 7
When Pocket
Charge 6K
charges a
phone. The
phone turns
on flight
mode.
1. Phone
cannot
identify
the Pocket
Charge 6K
when using a
non-genuine
cable or low
quality cable.
2. Cable
Connection
incorrectly
plugged in.
1. Use another
cable or use
the original
cable with
your device.
2. Reconnect
the cell phone
or adjust it to
normal mode.
The power
indicators
flash suddenly
1. The Pocket
Charge 6K
will warn and
cut o power
automatically
when the
internal
temperature
reaches 65°C
1. Please
disconnect
the cable
and place the
Pocket Charge
6K in a cool,
clean and well
ventilated
place.
Try again
when the
internal
temperature is
below 55°C.
Stops
charging a
device
1. No power
left
2. The load is
over limit
3. Short circuit
for protection.
1. Recharge
the Pocket
Charge 6K.
Page 8
Support
Having trouble with your Rapid Charge 11k?
Please contact us. No question too big or small
and we are more than happy to help.
Please visit:
www.kaiserbaas.com/support
Or email:
helpdesk@kaiserbaas.com
For further information please visit:
www.kaiserbaas.com/
Loading...