Kaile Electronics KL M03 User Manual

User’s Guide of KL-M03 Wireless Mouse

Note: For proper operation of the above devices, please take time to read the User’s Guide
carefully before using.

1. Notice:

FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for
help.

2. Preparation

1. Check to make sure the following components are available:
1 unit of wireless mouse
1 unit of mini nano receiver
2 pieces of AAA alkaline batteries

3. Turn on your host computer.

4. Take out the originally used mouse.

5. Install batteries for the mouse (See the following figure).
Step 1: Open the cover of the battery compartment;
Step 2: Install the required battery into the compartment;
Step 3: Close the cover of the battery compartment
Step 4: Pull down the button to turn on the power of mouse.

6. Plug the mini nano receiver into the USB port of the host computer

3. Note:

1. The units use the three-class of intelligent power-saving mode. The units switch to the

power-saving mode automatically when you stop moving the mouse. The lifetime of
battery for the mouse is from 2 to 4 months based on the usage frequency of the batteries.

2. When the mouse moves slowly or responds insensitively, the mouse battery is running low.

Please replace the battery timely.