Kaide KK-9502L Operating Instructions
Radio design :
1. Band Selector 9. AM/Time -
2. Reset 10. Time Mode
3. FM Stereo Led 11. AL Time Set
4. Tuning Knob 12. Antenna
5. Display 13 Supporting Rack
6. External Power Jack 14. Volume Control
7. Power/Sleep 15. Earphone Jack
8. FM/Time + 16. Handstrap
POWER
17. Battery Compartment
Battery installation :
1. Open the cover of the battery compartment and insert the battery in accordance with the polarity.
2. Please recharge battery if volume is low.
Battery recharge :
Through the charger :
1. Insert the battery into the charger.
2. Connect the charger with the wall socket.
3. When charging, the led is in red. When finished, the led will turn to green.
4. When finished, please disconnect the charger from power source.
To charge the battery inside the radio :
1. Connect one end of the power charger with the wall socket and the other end to the radio.
2. You can see the charging icon on the radio blinking .
3. The icon will stop to blink when the battery has been fully charged.
Note :
1. It will take about 5 hours to recharge the battery.
2. You cannot listen to the radio if you are charging the battery inside the radio.
3. The charger works for battery recharge only. It cannot provide external power to the radio.
RADIO LISTENING
Power on/off :
Short press the Power/Sleep button (7)to turn on the radio. You can turn off the radio by pressing the
same button.
Volume control :
Under the radio mode, you can adjust the volume through the volume tuning knob (14).
Band selection:
Under the radio mode, press the FM (8) button to receive FM stations. Press the AM (9) button to
receive AM stations. Then choose AM, SW 1-7 with the Band Selector (1).
Search station :
When you have selected the band, you can manual search the radio with the tuning knob (4) . You can
watch the tuning icon on the display to assist the tuning.
FM stereo:
1. You can enjoy stereo FM reception with earphones.
2. Move the Band Selector (1) to the FM Stereo position (right most) for stereo reception. The led
indicator will turn on.
3. You can turn to FM Mono (left most) by moving the Band Selector (1) also.
Reset :
You may need to use a needle to press the Reset (2) button if you encounter the following situations.
1. The screen does not have any display.
2. Buttons do not work.
Backlight :
You can press any key to turn on the backlight. It will stay on for a few seconds.
USE OF ANTENNA
1. AM : The built-in magnetic antenna inside the radio is used. Rotate body to get best reception.
2. FM : Extend the antenna. Try different angles to get the best reception
3. SW : Extend the antenna. Make the antenna vertical.
Loading...