TR-031-6S Remote Controller User Manual
Indoor Remote Controlled Countdown Timer
IMPORTANT SAFEGUARDS
NOTE: These are general definitions only; all may not pertain to the actual product purchased.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury. Usage of this signal word is limited to the most extreme situations.
WARNING: Indicates potentially hazardous situation, which, if not avoided, may result in
minor / moderate injury or product/ property damage. It also alerts against unsafe practices.
CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in
minor/moderate injury or product/ property damage. It also alerts against unsafe practices.
When using electrical products, always follow basic
safety precautions including the following:
WARNING-- To reduce the risk of fire, electric shock, or
serious personal injury
• Do not immerse the product in liquids
• Do not use an electrical device or appliance with this
product whose electrical specifications exceed those
specified in the “Electrical Specifications” section of this
manual.
• For Indoor use.
• Direct plug-in, Operating control.
• Temperature limits of the SWITCH HEAD: 0~40ºC
CAUTION-- To reduce the risk of personal injury or product/
property damage:
• This product is intended for non-commercial, non-industrial
use in the remote control of two electrical outlets.
Do not use this product for any other purpose.
Button Layout
1. Operating Mode:
Receiver
30
MinON60
2Hr 4Hr
Min
1
2
3
Transmitter
4
Features:
• Control electrical outlet up to a distance of 100 feet.
• Has two grounded receptacles.
• Weather resistant housing protects connected lighting.
• Countdown function automatically turns power off 30 min, 60 min, 2 Hr, 4Hr later.
Installation
1. Plug the Receiver into a standard 125-volt AC electrical outlet.
2. Confirm that the electrical specifications of an item you wish to use with this product do not
exceed those specified in the “Electrical Specifications” section. Plug the item into an outlet of
the Receiver.
3. Remove the plastic battery tab from the Battery Compartment in the back of the Remote
Control to activate the 3V pre-installed battery.
Operating Instructions
Control by transmitter:
1. Press the ON button on the transmitter to turn the receiver ON.
2. Press OFF button on the transmitter to turn the receiver OFF.
3. Press 30 min, 60 min, 2 Hr, 4Hr, to turn the receiver on and off after that specific min or hour.
Timer will turn ON, 30 min, 60 min,
2 Hr, 4Hr.
2. Select button:
To select the function and repeatedly.
Power ON 30 min 60 min 2 Hr
4Hr OFF ON
3. Outlets:
Plug the lights or devices to be
controlled by the timer into one of the
outlets.
4. Transmitter
Control by receiver:
1. Press the button. The power indicator will light and the two outlets are “ON”.
2. Press the button and select 30 min, 60 min, 2 Hr, 4Hr, to turn the receiver on and off
after that specific min or hour.
3. Continue pressing the button until all indicator lights are out. All two outlets are turned off.
ELECTRICAL RATINGS
Voltage Frequency Wattage Amperage Horse Power
1000W Tungsten60Hz125VAC 15A 1/2HP
* Maximum combined wattage for items using a tungsten bulb plugged into the Receiver is
1000W.
* 500 VA Electronic Ballast, 120 Vac, 60Hz, 8.3 A Ballast.
RECEIVER MODEL: TM-121
TRANSMITTER MODEL: TR-031-6S
FCC ID: PAGTR-031-6S
IC: 4494A-TR0316S
Battery Handling and Usage
WARNING: Keep batteries away from children and pets.
• Follow the battery manufacturer’s safety and usage instructions.
• Insert the battery observing the proper polarity (+/-) as indicated inside the Battery
Compartment.
• Remote a spent or discharged battery from the product. remove the battery when not using
the product for an extended period.
• Never throw batteries into a fire. Do not expose batteries to fire or other heat sources.
• Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste.
• Dispose or recycle spent / discharged batteries in compliance with all applicable laws. For
detailed information contact your local solid waste authority.
CAUTION: Failure to properly align the battery polarity can cause personal injury and/or
property damage.
Replacing the battery
• Remove the Battery compartment cover from the back of
the remote control.
• Remove the spent battery and place a new Type CR2032
battery into the Battery Compartment correctly observing
the polarity indications (+/-) inside the Battery Compartment.
• Replace the Battery Compartment Cover.
• Clear the battery contacts and also those of the device prior
to battery installation
Federal Communications Commission
Federal Communications Commission
Interference Statement
Interference Statement
This equipment has been tested and found to comply with the limits for Class B digital device,
This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio or television reception, which can be determined by
may cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
any interference received, including interference that may cause undesired operation.
FCC Caution: FCC Caution:
The Grantee is not responsible for any changes or modifications not expressly approved by the
party responsible for compliance. such modifications could void the user's authority to operate
the equipment.
Industry Canada statement:.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Déclaration d’Industrie Canada:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Responsible Party - U.S. Contact Information
Made in China
SAVE THESE INSTRUCTIONS!
Replacing the battery
Unique Identifier :
KAB Model No. : TM-121/TR-031-6S
Company Name :
Customer Address :
Tel/Internet Contact :
Loading...