KAB Enterprise TR 001 User Manual

MODEL TR-001 OUTDOOR REMOTE CONTROLLER

FCC

FCC ID : XXXTR-001

FCC FCC

ID : XXXTR-001

ID : XXXTR-001ID : XXXTR-001

FEDERAL COMMUNICATI ONS COM MISSION

This device comp lies wit h Part 15 of th e FCC rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, an d
(2) this device must accept any interference received, includin g interference that may
cause undesired operation.
NOTE Th is equipment has been tested and f ound to c omp ly with the limits for a
Clas s B digital device, p ursuant to Part 15 of the FCC Rules . These limits are
des igned to provide reas onable protect ion. This equipm ent gener ates, uses and can
rad iate radio freq uency energy and , if not in s talled and used in ac c or danc e with the
instructions, may cause harmful interference to radio communications. However,
there is n o guar antee t hat interference will not occur in a part icu lar inst allation. If this
equipm ent does cause har m ful interferenc e to rad io or television r ec eption, which
can be determ ined b y tur ning the equipm ent off and on, the user is encou r aged to try
to cor r ec t th e interfer ence by one or more of the following m eas ures :

- Reori ent or r elocat e the receiving antenna.

- Incr eas e the separat ion between the equipment and r ec eiv er.

- Connect the equipment into an outl et on a circuit diff er ent from that t o whic h the

receiver is connected.

- Shield ed interface c abl es mu s t be used in order to com ply wit h em is s ion lim its.

- Change or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate th e equ ipm ent.

- Cons ult th e dealer or an experienced r adio/TV technic ian for help.

SPECIFICATIONS

Frequency --- 315MHz
Transmitter Power Input --- DC 12V Battery
Receiver Power Inp ut --- AC 125V Electrical Outlet
Recei v er P ower Out put - - - 15 Amps / 125 Volt s / 1875 Watts

INSTALLATION

1. Mount the receiv er on wal l near g r ounded elec trical outlet. Nail or screw head must
extend at least 3/16” out f r om wall. Hang the rec eiver f r om slot on back of unit onto
nail or scr ew. Plug the power s upply c ord of the rec eiver into ou tlet. Then plug
device cor d into the receptac le at bottom of the receiver.

2. Install battery into the transmitter .

OPERA TION

1. Press ON bu tton on the transmitter to turn the receiver ON.

2. Press OFF button on th e trans m itt er to turn the receiver OFF.