Küpper 1112 User guide

PERFEKT I

Technical Data:

Cutting width with 90° 125 mm
Cutting width with 45° 75 mm
Cutting height 100 mm
Length of table 300 mm
Universal saw blade 420 mm

PRECISION MITRE SAW

for Craftsmen and Hobbyists

Instruction manual

Features:

1.) four guide rods garantee a solid and exact guie of saw-bow

2.) double fixed saw-blade

3.) adjusting of cutting angle: and automatic scanning permits a solid adjustment of the saw with
90° / 45° / 36° / 30° / 22,5°

4.) the thightening of this srew permits beyond the fixing of any desired cutting angle

5.) Annular srews with plastic layers make possible an easy saw guide

6.) clamp for the material to be cut may be clamped in order to prevent any movement on the

workbench a light pressure towards the back permits to make out the clamping jaw

7.) cutting depth adjuster: this bordered screw permits easily the adjusting of any desired cutting
depth

8.) an adjustable length stop must be srewed on the right or the left of the work-table. The stop

can easily be swung down, when it is not required

9.) double leaf springs allow an easy suspension of the saw on the guide bars, thus allowing the

operator an unimpeded two-hand arrangement of the material to be cut

10.) UNIVERSAL –saw-blade for wood, plastics, light metals.

Advisable for fix the saw with a vice on the work-table. Don’t exert pressure on the saw-bow, because
the teeth of the saw-blade will automatically cut the material. Move the saw-bow always parallel to the
table, never bevel.

INDICATION

1.) Fix moving arm (1) with bolt (2), washer (3) and countersunk screw (4) at the saw-table

(5).Attention: fix the srew just as tight as the moving arm doesn’t wiggle, but can move

easily. We recommend to fix the srew with Loctite

2.) Fix basic plate (6) with allen srew at the saw-table and put the rubber feets in the drilled

hole

3.) Move clamp for the material to be cut (8) on the spindle (9) of the saw-table

4.) Put annular srews with plastic layers (10) on the four guide rods (11) of the moving arm (1)

5.) Fix the adjustable length stop (12) on the left or right side of the saw-table