jWin PTP210 Owner's Manual

13-memory / Big-Button / Speaker

Phone with Flashing Ringer Light

Instruction Manual

PTP210

Telephone V10M10_IM_EN_06212010

INTRODUCTION

Thank you for purchasing PTP210. Please read and follow the
instructions in this manual carefully to ensure your product
operates correctly.

• Hands-free Speakerphone

• 3 One-Touch Dialing Memories (M1/M2/M3)

• 10 Two-Touch Dialing Memories

• Tone / Pulse Selectable

• Speakerphone Function

• Pause Function

• Music On Hold Function

• Redial Function

• Ringer Volume Control

• Speakerphone Volume Control

• Receiver Volume Control

What’s Included

• Warranty Card

• Handset cord

• Line cord

- 1 -

www.polaroid.com

Telephone V10M10_IM_EN_06212010

GETTING STARTED

Location of Controls

1
2
3

4
5

6

7

8
9

10

11

12

13
14

1. RINGER OFF / L / H 8. PAUSE

2. SPEAKER L / M / H 9. FLASH

3. RECEIVER

/ 10. MODE T / P

4. M1 / M2 / M3 11. AUTO

5. STORE 12. Keypad

6. Speaker 13. REDIAL

7. HOLD 14. SPEAKER

- 2 -

www.polaroid.com

Telephone V10M10_IM_EN_06212010

GETTING STARTED

Installation

1. Plug one end of coiled cord to the jack of handset and the
other end to the jack of the base set.

2. Plug one end of flat cord to line jack of the phone and the
other end to the wall jack

3. Open the battery compartment cover, install 3pcs AA
batteries (not Included)

Notes: Batteries are not included with the unit. When inserting
or replacing batteries, pick up the handset first, then replace the
batteries, otherwise, all settings and memory will be lost.

Basic Set Up

Tone/Pulse Selection

1. If your home is equipped with Touch Tone dialing service,
set selector to “T” (Tone).

2. If you have rotary service, set the selector to “P” (Pulse).

Note: In the pulse dial state, press ‘＊’ to change to tone dial.

Ringer Volume Control

1. Slide the [RINGER] switch to ‘HI’ or ‘LO’ to turn the ringer
on.

2. Slide the [RINGER] switch to ‘OFF’ to turn the ringer off.
You still can dial out, but cannot hear ringer sound of any
incoming calls. (Ringer LED will still flash when there is
an incoming call.)

Speaker Phone Volume Control

• Slide the [SPEAKER] switch to adjust the speaker volume
from HIGH/MEDIUM/LOW.

Receiver Volume Control

• Slide the [VOLUME] switch to adjust the receiver volume
from I to III

- 3 -

www.polaroid.com