JVC KENWOOD K2T001 Users Guide

(to the next page)
B. When card is at the left (near printing unit)
1.
Adjust the direction of the tilted card with your hand such that it is parallel with the card guide.
2.
Turn the knob of the card transfer in the anti­clockwise direction to transfer card to the stacker.
Card Transfer Knob
C. When card can barely be seen from the encoding unit
1.
Open the jog cover behind the card cassette, turn the jog dial in the anti-clockwise (upward) direction to move card into the encoder. Refer to Feed Jam (page 29 of this manual) on how to open the jog cover.
2.
If the inverter is not vertical, turn it to a vertical position with your hand.
3.
Install the ink cassette and close the printer door.
Refer to pages 13 and 14 of this manual.
Printer will start to initialize and return to the Ready mode.
3.
Turn the jog dial clockwise (down) to move card from the encoding unit to the inverter, followed by removing it with your hand.
4.
Install the ink cassette and close the printer door. Refer to pages 13 and 14 of this manual.
Printer will start to initialize and return to the Ready mode.
Jam Inside Laminator
Refer to the instruction manual of the laminating unit on procedures to remove the jammed card.
31
Troubleshooting (continued)
Procedures for Changing Thermal Head
CAUTION
discharged to the thermal head may cause it to break down. Before exchange, touch metal parts of the printer such as the screw to release the static electricity. Do not touch the heating unit of the thermal head with your hand. If you have done so, follow procedures on the page 25 of this manual to perform cleaning upon changing the thermal head. Carry out the work carefully and avoid knocking the heating unit of the thermal head against any hard object. Ensure that printer is switched off before changing. Do not loosen or remove any screws for which instructions are not given in the procedures.
1.
Place your fingers on top of the door and open by pulling it towards you.
Open slowly while supporting it with your hands.
Static electricity in our bodies
Remove sag
Eject cassette
CAUTION
careful not to drop the ink ribbon into the interior of the printer when removing the cassette.
When the ink ribbon is installed, be
2.
Remove ink ribbon cassette
Hold the lock lever with your fingers and lift it to unlock. When ink ribbon is installed, pull out the cassette by about 3cm and turn the knob on the cassette in the direction indicated by the arrow to tighten the ribbon sag. Remove the cassette while supporting it with both hands. Stand cassette on a flat and firm surface.
2
1
Unlock
3.
Open the door for head exchange
Remove the 2 fastening screws on the left of the printer’s head exchange door using a – (flathead) driver.
Slide the head exchange door to the left and remove by lifting it up.
2
1
32
4.
Move the head cooling fan.
Lift towards you and lean it backwards.
5.
Remove head cables A and B.
Hold the part of cable that is directly above the connector and remove by lifting them up carefully one by one.
(to the next page)
View from the top
Head shaft Head bracket
7.
Install a new thermal head
Be careful not to hit the heating element of the thermal head against any hard object. Reverse steps in 6. to install the thermal head while paying attention not to catch the head cable.
B
A
6.
Remove the thermal head.
To remove the thermal head from the shaft, hold and move it to the left while pulling forward. Lift it up while leading it through from underneath the head bracket.
Heating Unit
Check if the guide bearing of the thermal slot is inside the guiding slot.
Guiding Groove
Guide Bearing
2
1
33
Loading...
+ 6 hidden pages