TKR-851-2 FCC ID: K4435583120
INSTRUCTION MANUAL
TKR-851-2
THANK YOU!
We are grateful you purchased this
effective in your communications system, and will keep personnel operating at peak efficiency.
KENWOOD
you will be pleased with the quality and features of this product.
FEATURES
• You can easily program channel data using the KPG-91D software on a PC.
• You can recall 1 of 16 preset channels using either a PF key or the external control line.
• The firmware can be written to the Flash memory through an external source.
• QT/DQT signalling can be programmed on each channel. It simultaneously decodes up to 16 different QT/DQT
tones.
• Air Remote Control Function.
• The interface port can be used with external equipment, such as a repeater controller.
• The repeater has multi-mode capability.
Wide: 30 kHz / Narrow: 15 kHz (TKR-751; K type only)
Wide: 25 kHz/ Narrow: 12.5 kHz (TKR-751/TKR-851)
• You can adjust the following functions from a PC:
• Squelch
• RX Audio Signal Output (RA)
• RX Detector Signal Output (RD)
• RX Frequency
• RF Output Power
• Maximu m Devi ation
• TX Audio Input (TA)
• Signaling Deviation (TD)
• DQT Balance
• QT Deviation
• DQT Deviation
• Test Tone Deviation
• CW ID Deviation
• Repeat Gain
• TX Frequency
• DTMF Deviation
• Courtesy Tone Deviation
• Battery Operating Tone Deviation
• Battery Warning Tone Deviation
• Power Down Detect
• 5 Tone Deviation (M type only)
incorporates the latest in advanced technology into all of our products. As a result, we feel strongly that
KENWOOD
repeater. We believe this easy-to-program repeater will be highly
TKR-851-2 FCC ID: K4435583120
PRECAUTIONS
• Do not expose the unit to rain or moisture; to prevent fire or electric shock.
• Do not open the unit under any circumstances; to avoid risk of electric shock.
• Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces.
• If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately.
Contact your
KENWOOD
service center or dealer.
NOTICES TO THE USER
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may
cause harmful interference unless the modifications are expressly approved in the instruction manual. The user
could lose the authority to operate this equipment if an unauthorized change or modification is made.
** GOVERNMENT LAW PROHIBITS THE OPERATION OF UNLICENSED RADIO TRANSMITTERS
WITHIN THE TERRITO RIES UNDE R GOVERNMEN T CONTROL.
** ILLEGAL OPERATION IS PUNISHABLE BY FINE OR IMPRISONMENT OR BOTH.
** REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
CAUTION:
This repeater is intended for use as a fixed base station with the antenna located outdoors on the
rooftop or on antenna tower.
UNPACKING AND CHECKING EQ UIPMENT
The following unpacking information is for use by your
Note:
facility, or th e factory.
Carefully unpack the repeater. We recommend that you identify the items listed in the following table before discarding
the packing material. If any items are missing or have been damaged during shipment, file a claim with the carrier
immediately.
Item Part Number Quantity
Hardware fixture J21-8402-#4 1
Front Glass B10-2635-#4 1
Filter B11-1259-#4 1
Cushion G13-1801-#4 4
Cushion G13-1802-#4 4
Foot J02-0475-#5 2
Foot J02-0492-#4 2
Grommet J59-0302-#5 2
Handle K01-0418-#5 1
Screw N30-4006-46 2
Screw N35-3006-45 5
DC Cord E30-3427-#5 1
Connector Cable E31-3228-#5 1
Fuse F06-1032-#5 1
Instruction Manual B62-1775-## 1
Warranty Card 1
KENWOOD
dealer, an authorized
KENWOOD
service