JVC UXP-3, UXP-5 Owners manual

MICRO COMPONENT SYSTEM

UX-P5 — Consists of CA-UXP5 and SP-UXP5. UX-P3 — Consists of CA-UXP3 and SP-UXP3.

COMPACT

DIGITAL AUDIO

CD-R/RW PLAYBACK

STANDBY/ON

DISPLAYDIMMER

AUTO

SOUND

PRESET

MODE

CANCEL MULTI KEY SET

AHB PRO

RM-SUXP5U REMOTE CONTROL

MICRO COMPONENT SYSTEM UX·P5

STANDBY / ON

AHB PRO

CD TAPE FM/AM

STANDBY/ON

SLEEP

MD/AUX

REPEATRANDOMPROG

FM/AM

FM MODE

TAPE

VOLUME

DIRECT OPERATING

SOUND

REC

PHONES

AUTO REVERSE

CLOCK

MD/AUX

VOLUMEFUNCTION

TIMER

REV.MODE

REC

SP-UXP5 CA-UXP5 SP-UXP5

INSTRUCTIONS

COMPACT

DIGITAL AUDIO

CD-R/RW PLAYBACK

STANDBY

DISPLAY

AUTO

SOUND

PRESET

MODE

CANCEL MULTI KEY SET

AHB PRO

RM-SUXP3U REMOTE CONTROL

MICRO COMPONENT SYSTEM UX·P3

STANDBY / ON

AHB PRO

CD TAPE FM/AM

STANDBY/ON

SLEEP

AUX

REPEATRANDOMPROG

FM/AM

FM MODE

TAPE

VOLUME

DIRECT OPERATING

SOUND

AUTO REVERSE

PHONES

AUTO TAPE SELECTOR

CLOCK

AUX

VOLUMEFUNCTION

TIMER

REV.MODE

REC

SP-UXP3 CA-UXP3 SP-UXP3

For Customer Use:

Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference.

Model No. Serial No.

GVT0053-003A

[US, UN, UJ]

For UX-P5:

Warnings, Cautions and Others

Caution –– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely (the STANDBY/ON lamp goes off). The switch in any position does not disconnect the mains line.

• When the unit is on standby, the STANDBY/ON lamp lights red.

• When the unit is turned on, the STANDBY/ON lamp lights green. The power can be remote controlled.

For UX-P3:

Caution –– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled.

– G-1 –

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1. Do not remove screws, covers or cabinet.

2. Do not expose this appliance to rain or moisture.

CAUTION

• Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

• Do not place any naked flame sources, such as lighted candles, on the apparatus.

• When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly.

• Do not use this apparatus in a bathroom or places with water. Also do not place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this apparatus.

– G-2 –

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown by the dimensions below.

3 Bottom:

Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.

15 cm

1 cm

UX-P5/UX-P3

15 cm

1 cm

15 cm

10 cm

– G-3 –

15 cm

UX-P5 UX-P3

REPRODUCTION OF LABELS /

IMPORTANT FOR LASER PRODUCTS

1 CLASSIFICATION LABEL, PLACED ON REAR ENCLO-

SURE

CLASS 1 LASER PRODUCT

1. CLASS 1 LASER PRODUCT

2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3. CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

2 WARNING LABEL, PLACED INSIDE THE UNIT

CAUTION: Invisible laser radiation when open and interlock failed or defeated. AVOID DIRECT EXPOSURE TO BEAM. (e)

ADVARSEL: Usynlig laserstråling ved åbning, når sikkerhedsafbrydere er ude af funktion. Undgå udsættelse for stråling (d)

VARNING: Osynlig laserstrålning när denna del är öppnad och spärren är urkopplad. Betrakta ej strålen. (s)

VARO: Avattaessa ja suojalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Älä katso säteeseen. (f)

– G-4 –

Introduction

English

We would like to thank you for purchasing one of our JVC products.

Before operating this unit, read this manual carefully and thoroughly to

obtain the best possible performance from your unit, and retain this manual

for future reference.

About This Manual

This manual is organized as follows:

• The manual mainly explains operations using the

buttons on the remote control. You can use the buttons both on the remote control and on the unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise.

• Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Common Operations” on pages 10 to 12.

• The following marks are used in this manual:

Gives you warnings and cautions to prevent from damage or risk of fire/electric shock. Also gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Power sources

• When unplugging from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

• After starting heating in the room

• In a damp room

• If the unit is brought directly from a cold to a warm place

Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again.

Others

• Should any metallic object or liquid fall into the unit, unplug the unit and consult your dealer before operating any further.

• If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

Precautions

Installation

• Install in a place which is level, dry and neither too hot nor too cold — between 5˚C (41˚F) and 35˚C (95˚F).

• Install the unit in a location with adequate ventilation to prevent internal heat built-up in the unit.

• Leave sufficient distance between the unit and the TV.

• Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Location of the Buttons and Controls....................... 3

Front Panel ................................................................. 3

Remote Control .......................................................... 5

Getting Started............................................................ 6

Supplied Accessories.................................................. 6

Putting the Batteries into the Remote Control ........... 6

Connecting Antennas ................................................. 6

Connecting Speakers .................................................. 7

Connecting Other Equipment..................................... 8

Adjusting the Voltage Selector ................................... 9

English

Playing Back CDs (CD/CD-R/CD-RW).................. 14

Playing Back the Entire CD — Normal Play........... 14

Basic CD Operations................................................ 14

Programming the Playing Order of the Tracks

— Program Play ................................................. 15

Playing at Random — Random Play ....................... 16

Repeating Tracks — Repeat Play............................. 16

Prohibiting Disc Ejection — Tray Lock................... 16

Playing Back Tapes ................................................... 17

Playing Back a Tape ................................................. 17

Common Operations ................................................ 10

Turning On the Po wer ............................................... 10

Setting the Clock ...................................................... 10

Setting the AM Tuner Interval Spacing.................... 11

Selecting the Sources and Starting Play ..................... 11

Adjusting the Volume ............................................... 11

Selecting the Display Brightness

(ONLY FOR UX-P5) .......................................... 11

Reinforcing the Bass Sound ..................................... 12

Selecting the Sound Modes ...................................... 12

Listening to FM and AM Broadcasts...................... 13

Tuning in a Station ................................................... 13

Presetting Stations .................................................... 13

Tuning in a Preset Station ........................................ 13

Recording .................................................................. 18

Recording on a Tape ................................................. 18

CD Direct Recording................................................. 19

One Track Recording ................................................ 19

Using the Timers....................................................... 20

Using Daily Timer and Recording Timer................. 20

Using Sleep Timer.................................................... 21

Maintenance .............................................................. 22

Troubleshooting ........................................................ 23

Specifications............................................................. 24

– 2 –

Location of the Buttons and Controls

English

Become familiar with the buttons and controls on your unit.

Front Panel

UX-P5

STANDBY/ON

UX-P3

STANDBY

4 5

UX-P5

MD/AUX

STANDBY / ON

AHB PRO

SOUND

DIRECT OPERATING

COMPACT

DIGITAL AUDIO

MICRO COMPONENT SYSTEM

CD TAPE FM/AM

CD-R/RW PLAYBACK

VOLUMEFUNCTION

CLOCK

TIMER

i o

;

UX-P3

AUX

(ONLY FOR

UX-P5)

PHONES

REC

AUTO REVERSE

– 3 –

REV.MODE

a s

REC

Display Window

Continued

English

[

DAIL Y REC SLEEP

CLOCK PRGM

RANDOM

See pages in the parentheses for details.

Front Panel

1 Remote sensor 2 For UX-P5: STANDBY/ON lamp (10)

For UX-P3: STANDBY lamp (10)

3 (STANDBY/ON) button (10, 11, 16, 21) 4 TAPE 2 3 button (10, 17, 18)