LVT1167-005A
[J]
SP-XF70
INSTRUCTIONS: SATELLITE SPEAKER SYSTEM
Thank you for purchasing JVC speakers.
Before you begin using them, please read the instructions carefully.
SP-XF70 consist of the following:
Warnings, Cautions and Others
Precautions for installation
• Do not install the speakers on an uneven surface or in a place subject to vibration; otherwise, they may fall over, causing damage or injury.
• The speakers are magnetically shielded to avoid color distortions on TVs if they are installed properly.
– When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main power switch again. If there are still distortion, move the speakers further away from the TV.
Precautions for daily use
• Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup.
• When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage, or injury.
• When holding a speaker, always grasp the lower portion.
Checking the Components
Check to be sure you have the following components.
The number in parenthesis indicates the quantity of the piece supplied.
If any of the items above are missing, contact your dealer immediately.
• Speaker cords— 4 m (13.1 feet) (3): For front/center speakers
• Speaker cords— 10 m (32.8 feet) (3): For surround/surround back speakers
• Screws— M5 x 25 mm (M5 x 1 in.) (8)
Surround
speakers (2)
Front
speakers (2)
Stands (4) Base plates (4)
Center speaker (1)
Surround back
speaker (1)
SP-XF70C
SP-XF30S
SP-XF30F
SP-XF30F
SP-XF30S
SP-XF70S
– 1 –
LIMITED WARRANTY
PARTS LABOR
1
YR
1
YR
JVC COMPANY OF AMERICA
DIVISION OF JVC AMERICAS CORP.
1700 Valley Road
Wayne, NJ 07470
AUDIO-1
BT-51001-5
(0301)
QUALITY SERVICE
HOW TO LOCATE YOUR JVC SERVICE CENTER
Dear Customer,
In order to receive the most satisfaction from your purchase,please read the instruction booklet before
operating the unit.In the event that repairs are necessary, please call 1 (800)537-5722 for your nearest
authorized servicer or visit our website at www.JVC.com
Remember to retain your Bill of Sale for Warranty Service.
Do not service the television yourself
Caution
To prevent electrical shock,do not open the cabinet.There are no user serviceable
parts inside.Please refer to qualified service personnel for repairs.
Accessories
To purchase accessories for your JVC product,please call toll free:1 (800)882-2345 or
on the web at www.JVC.com
TOLL FREE: 1 (800) 537-5722
http://www.jvc.com
Authorized Service Centers
®
0204NSMMDWHCE
EN
© 2004 Victor Company of Japan, Limited
SURROUND
SPEAKERS
LEFTRIGHT LEFTRIGHT
CENTERFRONT
CENTER
FRONT LEFT
FRONT RIGHT
SURROUND RIGHT
SURROUND LEFT
SURROUND BACK
SURROUND
BACK
– 3 –
4
3
2
SP-XF30S
SP-XF30F
1
to
6
Without stand: Refer to Steps 1 to
5
or
or
With standWithout stand Without stand
Connections
Connecting the speaker system to the amplifier
Before connecting—
• Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged.
• The impedance of each speaker is 6 Ω. Before connecting them to your amplifier, check the speaker impedance range of your amplifier. If the impedance of this
speaker is out of the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier.
• The maximum power handling capacity of the speakers are 100 W. Excessive input will result in abnormal noise and possible damage.
• Be sure to turn down the volume level to prevent unwanted noise before performing following operations:
– Turning on or off other components,
– Operating the amplifier,
– Tuning FM stations,
– Fast-forwarding a tape,
– Continuously reproducing high frequency oscillation or high pitch electronic sounds.
• When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers.
• Before replacing the cartridge, always turn off the power to the turntable; otherwise, the clicking noise may damage the speakers.
Connecting the Center speaker
Press ReleaseInsert
Black striped
Copper
Red
Black
Route the cord
Speaker cord
Base plate
(Rear side)
Speaker cord
Stand (or
speaker directly)
Base plate
Screw—
M5 x 25 mm
(M5 x 1 in.)
Copper
Speaker
cord
Red
White
Black
Front left
Subwoofer
Amplifier
Surround right
Surround left
Center
Surround back
Front right
Typical connection method to an amplifier
Connect the speakers to the speaker terminals of the amplifier with the
speaker cords by referring to the diagram below.
• Make sure to match the polarity (ª and
·) when connecting the speaker cords.
• The diagram below is an example of a
typical connection.
Connecting the Surround back speaker
Black striped
Copper
Red
Black
Press
ReleaseInsert
Speaker layout
Specification
SP-XF30F (Front speakers)
Type: 2-way 3-speaker Bass reflex type (Magnetically-shielded type)
Speaker unit: 5.5 cm (2 3/16 in.) cone (× 2), 3.0 cm (1 1/16 in.) dome
Frequency range: 95 Hz to 40 000 Hz
Input impedance: 6 Ω
Power handling Capacity: 100 W
Sound pressure level: 80 dB/W•m
Dimensions (W × H × D) (approx.):
250 mm × 1103 mm × 250 mm
(9 7/8 in. × 43 7/16 in. × 9 7/8 in.)
Mass (approx.): 3.67 kg (8.1 lbs) each
SP-XF30S (Surround speakers)
Type: 2-way 3-speaker Bass reflex type (Magnetically-shielded type)
Speaker unit: 5.5 cm (2
3
/16 in.) cone (× 2), 3.0 cm (1 1/16 in.) dome
Frequency range: 90 Hz to 40 000 Hz
Input impedance: 6 Ω
Power handling Capacity: 100 W
Sound pressure level: 77 dB/W•m
Dimensions (W × H × D) (approx.):
250 mm × 1103 mm × 250 mm
(9 7/8 in. × 43 7/16 in. × 9 7/8 in.)
Mass (approx.): 3.83 kg (8.5 lbs) each
SP-XF70C (Center speaker)
Type: 2-way 3-speaker Bass reflex type (Magnetically-shielded type)
Speaker unit: 5.5 cm (2 3/16 in.) cone (× 2), 3.0 cm (1 1/16 in.) dome
Frequency range: 90 Hz to 40 000 Hz
Input impedance: 6 Ω
Power handling Capacity: 100 W
Sound pressure level: 81 dB/W•m
Dimensions (W × H × D) (approx.):
209 mm × 85 mm × 92 mm
(8 1/4 in. × 3 3/8 in. × 3 5/8 in.)
Mass (approx.): 0.87 kg (2.0 lbs)
SP-XF70S (Surround back speaker)
Type: 2-way 3-speaker Bass reflex type (Magnetically-shielded type)
Speaker unit: 5.5 cm (2 3/16 in.) cone (× 2), 3.0 cm (1 1/16 in.) dome
Frequency range: 90 Hz to 40 000 Hz
Input impedance: 6 Ω
Power handling Capacity: 100 W
Sound pressure level: 78 dB/W•m
Dimensions (W × H × D) (approx.):
84 mm × 211 mm × 120 mm
(3 5/16 in. × 8 5/16 in. × 4 3/4 in.)
Mass (approx.): 0.96 kg (2.2 lbs)
– 4 –– 2 –
Loading...