JVC CA-UXNB7DAB, SP-UXNB7DAB, UX-NB7DAB User Manual
MICRO COMPONENT SYSTEM
UX-NB7DAB
—Consists of CA-UXNB7DAB and SP-UXNB7DAB
INSTRUCTIONS
GNT0065-025A
[B]
Warnings, Cautions and Others
CAUTION — button!
Disconnect the mains plug to shut the power off
completely. When installing the apparatus, ensure that the
plug is easily accessible.
The button in any position does not disconnect the
mains line. The power can be remote controlled.
• When the unit is on standby, the STANDBY lamp lights
red.
• When the unit is turned on, the STANDBY lamp goes off .
CAUTION
To reduce the risk of electrical shocks, fi re, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
CAUTION:
• Do not block the ventilation openings or holes. (If
the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to
get out.)
• Do not place any naked fl ame sources, such as lighted
candles, on the apparatus.
• When discarding batteries, environmental problems
must be considered and local rules or laws governing
the disposal of these batteries must be followed
strictly.
• Do not expose this apparatus to rain, moisture,
dripping or splashing and that no objects fi lled with
liquids, such as vases, shall be placed on the apparatus.
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no
user serviceable parts inside the unit; leave all servicing
to qualifi ed service personnel.
3. CAUTION: Visible and/or invisible class 1M laser
radiation when open. Do not view directly with optical
instruments.
4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED
INSIDE THE UNIT.
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment.
If the plug fi tted is not suitable for the power points in
your home or the cable is too short to reach a power
point, then obtain an appropriate safety approved
extension lead or consult your dealer.
BE SURE to replace the fuse only with an identical
approved type, as originally fi tted.
If nonetheless the mains plug is cut off ensure to
remove the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvertent
connection to the mains supply.
If this product is not supplied fi tted with a mains plug
then follow the instructions given below:
IMPORTANT:
DO NOT make any connection to the terminal which is
marked with the letter E or by the safety earth symbol
or coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured
in accordance with the following code:
Blue: Neutral
Brown: Live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
IF IN DOUBT - CONSULT A COMPETENT
ELECTRICIAN.
Dear Customer,
This apparatus is in conformance with the valid
European directives and standards regarding
electromagnetic compatibility and electrical safety.
European representative of Victor Company of Japan,
Limited is:
JVC Technology Centre Europe GmbH
Postfach 10 05 52
61145 Friedberg
Germany
G-1
CAUTION: Proper Ventilation
To avoid risk of electric shock and fi re, and to prevent damage, locate the apparatus as follows:
1. Front: No obstructions and open spacing.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a
height of 10 cm or more.
Front view Side view
15 cm
1 cm
SP-UXNB7DAB CA-UXNB7DAB SP-UXNB7DAB CA-UXNB7DAB
About the cooling fan
A cooling fan is mounted on the rear panel of the unit to prevent abnormal temperature inside the unit, thus
assuring normal operation of the unit.
Information for Users on Disposal of Old Equipment
Attention:
This symbol is only
valid in the European
Union.
15 cm
1 cm
[European Union]
This symbol indicates that the electrical and electronic equipment should not be disposed as
general household waste at its end-of-life. Instead, the product should be handed over to the
applicable collection point for the recycling of electrical and electronic equipment for proper
treatment, recovery and recycling in accordance with your national legislation.
By disposing of this product correctly, you will help to conserve natural resources and will
help prevent potential negative eff ects on the environment and human health which could
otherwise be caused by inappropriate waste handling of this product. For more information
about collection point and recycling of this product, please contact your local municipal offi ce,
your household waste disposal service or the shop where you purchased the product.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national
legislation.
(Business users)
If you wish to dispose of this product, please visit our web page www.jvc-europe.com to
obtain information about the take-back of the product.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in accordance with applicable national
legislation or other rules in your country for the treatment of old electrical and electronic
equipment.
15 cm
15 cm
15 cm
10 cm
The model information is located on the bottom.
G-2
Contents
Precautions ...........................................................2
Getting Started .....................................................2
Supplied Accessories ...............................................................2
Prepare the Remote Control .................................................2
Connections ................................................................................ 3
Basic and Common Operations ...........................5
Operating on the System .......................................................5
Display Information ..................................................................5
Operating on the Remote Control ...................................... 6
Playing Back Discs ................................................7
To Set a Disc ................................................................................7
Basic Disc Operations ..............................................................7
Playing at Random—Random Play ....................................8
Playing Repeatedly—Repeat Play
Programming the Playing Order—Program Play
(except for MP3) .................................................................... 8
Listening to the Radio ..........................................9
Basic Tuner Operations ............................................................9
What is DAB system? ............................................................. 10
Changing the DAB Information ........................................ 10
Improving the DAB reception ............................................ 10
Scanning ensembles ............................................................. 10
Receiving FM stations with Radio Data System ..........11
Changing the Radio Data System Information ............ 11
Searching for Programs by PTY Codes
(PTY Search) ......................................................................... 11
Switching Temporarily to a Program of Your Choice
Automatically ...................................................................... 12
Presetting Stations and Services ...................................... 12
Connecting a Portable Audio Device ................13
Playing back a portable audio device ............................. 13
Recording to a portable audio device ............................ 14
Setting the Clock and Daily Timer .....................15
Setting the Clock .................................................................... 15
Setting the Daily Timer ......................................................... 15
Learning More about This System .....................16
Troubleshooting .................................................17
Maintenance .......................................................18
Specifi cations ......................................................18
Description of the PTY codes for Radio Data
System and DAB ..............................................19
............................................ 8
1
Precautions
Notes on the power cord
• When you are away on travel or otherwise for an
extended period of time, remove the plug from the
wall outlet. A small amount of power (2.5 W) is always
consumed while the power cord is connected to the
wall outlet.
• When unplugging the System from the wall outlet,
always pull the plug, not the power cord.
• Do not handle the power cord with wet hands.
• Disconnect the power cord before cleaning the System
or moving the System.
• Do not alter, twist or pull the power cord, or put
anything heavy on it, which may cause fi re, electric
shock, or other accidents.
• If the cord is damaged, consult a dealer and have the
power cord replaced with a new one.
Avoid moisture, water, dust, and high temperatures
• Do not place the System in moist or dusty places.
• If water gets inside the System, turn off the power and
remove the plug from the wall outlet, then consult your
dealer. Using the System in this state may cause a fi re or
electrical shock.
• Do not expose the System to direct sunlight or place it
near a heating device.
Notes on installation
• Select a place which is level, dry and neither too hot nor
too cold between 5˚C and 35˚C.
• Do not install the System in a place subject to vibrations.
• Do not put heavy objects on the System.
To prevent malfunction or damage of the System
• Do not insert any metallic objects, such as wires,
hairpins, coins, etc. into the System.
• Do not block the vents.
To clean the cabinet
• Use a soft cloth. Follow the relevant instructions on the
use of chemically-coated cloths.
• Do not use benzene, thinner or other organic solvents
and disinfectants. These may cause deformation or
discoloring.
There are no user-serviceable parts inside. If
anything goes wrong, unplug the power cord
and consult your dealer.
Getting Started
Supplied Accessories
After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the
quantity of each piece supplied.
• Remote control (x 1)
• Lithium coin battery CR2025 (x 1) (The battery has
been installed when shipped from the factory.)
• AM loop antenna (x 1)
• FM antenna (x 1)
• DAB antenna (x 1)
If anything is missing, consult your dealer immediately.
Prepare the Remote Control
When you use the remote control for the fi rst time, pull
out the insulation sheet.
Insulation sheet
Replacing the Battery in the Remote Control
Insert the battery into the remote control by matching
the polarity (+ and –) correctly.
Lithium coin battery
(product number: CR2025)
NOTES
• Store the battery in a place where children cannot
reach. If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the battery
or dispose of it in a fi re. Doing any of these things may
cause the battery to give off heat, crack, or start a fi re.
• Do not leave the battery with other metallic materials.
Doing this may cause the battery to give off heat, crack,
or start a fi re.
• When throwing away or saving the battery, wrap it in
tape and insulate; otherwise, the battery may start to
give off heat, crack, or start a fi re.
• Do not poke the battery with tweezers or similar tools.
Doing this may cause the battery to give off heat, crack,
or start a fi re.
• Dispose of battery in the proper manner, according to
federal, state, and local regulations.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
2
Connections
Do not connect the AC power cord until all other connections have been made.
NOTES
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep
the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause
poor reception.
• If the cords are covered with vinyl, remove the vinyl to expose the tip of the cord by twisting the vinyl.
DAB antenna (supplied)
Extend the wire so that you can
receive your desired ensembles.
For better DAB reception
Disconnect the supplied DAB antenna, and connect an active
antenna.
(See “Improving the DAB reception” on page 10.)
Active antenna
(not supplied)
FM antenna (supplied)
Extend it so that you can
obtain the best reception.
PHONES
SPEAKERS
RIGHT
IMPEDANCE
MIN
LEFT
DAB
ANTENNA
COAXIAL
LOOP
AM EXT
To connect the speaker cords
Make sure the both speakers are connected
To a wall outlet
Plug the AC power cord only after
all connections are complete.
correctly and fi rmly.
When connecting the speaker cords, match the
polarity of the speaker terminals: white cord to (+)
and white cord with black stripe to (–).
3
To connect the AM loop antenna
1 Hold
2 Insert
3 Release
AM loop antenna (supplied)
Turn it until the best reception is obtained.
For better FM/AM reception
Disconnect the supplied FM antenna,
and connect to an outdoor FM antenna
using a 75 W wire with coaxial type
connector (IEC or DIN45325).
To assemble the AM loop antenna
Outdoor FM antenna
(not supplied)
Vinyl-covered wire (not supplied)
Extend it horizontally.
AM loop antenna
Keep it connected.
1 Hold
2 Insert
NOTES
• DO NOT connect more than one speaker
to each terminal.
• DO NOT allow the conductor of the
speaker cords to be in touch with the
metallic parts of the System.
3 Release
4
Basic and Common Operations
Operating on the System
To Press
Turn on or off
(standby) the power
The standby lamp on the System turns off /on.
See “Playing Back Discs” on page 7.
Using Headphones
Be sure to turn down the
volume before connecting
or wearing the headphones.
• Connecting the headphones
will deactivate the speakers.
Select a source*
Adjust the volume
* You can operate the source select buttons on the
System only touch lightly, because these buttons are
“touch sensor panel.”
If you touch any one of these buttons, they lights in
orange briefl y.
NOTE
DO NOT turn off (standby) the System with the volume
set to an extremely high level; Otherwise, the sudden
blast of sound can damage your hearing, speakers and/or
headphones when you turn on the System or start
playback.
See “Listening to the Radio” on page 9.
See “Connecting a Portable Audio Device”
on page 13.
You can adjust the volume level from level 0
(VOL MIN) to level 31 ( VOL MAX).
Display Information
Disc play mode indicators (See page 8.)
Tuner mode indicators
(See page 9 and 12.)
Timer mode indicators
(See page 6 and 15.)
STANDBY lamp
QP Link indicator
(See page 13.)
AHB PRO and A.STBY indicator (See page 6.)
5
Main Display
Loading...