SDI OUT
SA-X65U
For Customer Use:
Enter below the Serial No. which is
located on the body. Retain this
information for future reference.
Model No. SA-X65U
Serial No.
INSTRUCTIONS
SDI OUT
AES/EBU OUT
This instruction book is made from
100% recycled paper.
LLT0065-001B
SAFETY PRECAUTIONS (FOR USA AND CANADA)
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
Note:
The rating plate (serial number plate) is
on this unit.
INFORMATION
This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference in which
case the user will be required to correct
the interference at his own expense.
CAUTION
CHANGES OR MODIFICATIONS NOT
APPROVED BY JVC COULD VOID
USER’S AUTHORITY TO OPERATE
THE EQUIPMENT.
AVERTISSEMENT:
POUR EVITER LES RISQUES
D’INCENDIE OU D’ELECTRO-CUTION,
NE PAS EXPOSER L’APPAREIL A
L’HUMIDITE OU A LA PLUIE.
REMARQUE:
La plaque d’identification (numéro de
série) se trouve sur l’appareil.
INFORMATION (FOR CANADA)
RENSEIGNEMENT (POUR CANADA)
This Class A digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de la
Class A est conforme à la norme
NMB-003 du Canada.
THIS DEVICE COMPLIES WITH PART
15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED
OPERATION.
2
SAFETY PRECAUTIONS (FOR EUROPE)
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
WARNING
This is a Class A product. In a domestic
environment this product may cause
radio interference in which case the user
may be required to take adequate
measures.
Supplement
This equipment is in conformity with the provisions and protection requirements of the
corresponding European Directives. This equipment is designed for professional video
appliances and can be used in the following environments:
■ Controlled EMC environment (for example purpose built broadcasting or recording
studio), and the rural outdoors environment (far away form railways, transmitters,
overhead power lines, etc)
In order to keep the best performance and furthermore for electromagnetic compatibility we
recommend to use cables not exceeding the following lengths:
Port Cable Length
SDI OUT Coaxial cable 10 meters
AES/EBU OUT Coaxial cable 10 meters
Caution
Where there are strong electromagnetic waves or magnetism, for example near a radio
or TV transmitter, transformer, moter, etc., the picture and sound may be disturbed.
In such a case, please keep the apparatus away from the sources of the disturbance.
3
Thank you for purchasing
the SA-X65U SDI OUT
By connecting the SDI output board to the DV VIDEOCASSETTE RECORDER BR-DV6000,
serial digital video signals (SMPTE259M-compliant) and digital audio signals (AES/EBU)
can be output.
• This board also simultaneously outputs EMBEDDED AUDIO.
About restrictions of BR-DV6000
• In case, these two models with bottom 4 digits of serial number is more than below
number, it is compatible with SA-X65U. BR-DV6000U #0651, BR-DV6000EC #0191
• BR-DV6000E marked with (B) on the Rating Label is compatible with SA-X65U.
( Bottom 4 digits of serial number is more than #0881 )
For details, please contact your JVC dealer.
Part names and Functions
[FRONT]
q [SDI OUT] SDI output connector
Output serial digital video signal
(SMPTE259M – compliant).
The EMBEDDED AUDIO
(SMPTE272M – compliant) is simultaneously output.
Caution
To avoid causing malfunction, please do not touch this
terminal except when connecting cable to it.
SDI OUT
q
w [AES/EBU OUT] Digital audio output connector
AES/EBU OUT
w
Outputs digital audio interface standard (AES/EBU)
digital audio signals.
e
e Mounting screw hole
These are the screw holes for mounting the SA-X65U
SDI OUT to the BR-DV6000.
MEMO
• The embedded audio is only compatible with channels 1 and 2. The same data which
is output on channels 1 and 2, is also output on channels 3 and 4.
• The embedded audio and AES/EBU are output in 48 kHz/20 bit mode regardless of
the original source.
• In the case of the following, “NO EMBEDDED AUDIO” may temporarily be detected
by the connected device:
• When the VTR mode is switched such as STOP → PLAY mode, etc.
• When the input selection of BR-DV6000 is switched, or when input signals or
reference signals are inserted/removed.
• When unrecorded portion of a tape is played back.
• When the audio sample frequency mode is switched.
4
Part names and Functions (continued)
[SIDE]
r Setting switch
Setting switches for factory adjustment
only.
1
2ON
3
4
5
6
7
8
1
O
N
2
3
4
5
6
7
8
S201
r
Caution
• Do not change the settings for switch
(S201).
• 3, 5, and 7 are initially set to ON for switch
(S201), all of the other values are set to
OFF.
Installation Procedures
The replacement procedure is described below. However, to prevent electrical shock or
injury, the work should be performed only by a qualified personnel or a JVC authorized
service agent.
Caution
To prevent electrical shock, remove the AC
adaptor before installing SA-X65U.
Screws
A
1 Remove the slot cover by removing the two
A screws, which are securing the cover.
SDI OUT
AES/EBU OUT
2 Insert SA-X65U into BR-DV6000.
3 Fix SA-X65U to BR-DV6000 with the two A
screws, removed in 1.
4 Tu rn on the BR-DV6000 power.
Screws
A
5
Indication on the LCD
Attach the SA-X65U SDI OUT to the BR-DV6000, and the SDI card status will be displayed
on the LCD screen of the BR-DV6000.
The card status is displayed when setting the LCD screen to the Enlarged display mode.
LCD screen
CH1/3
48k
L
CH2/4
NDF
T
C
FREE
12H 34M 34S10F
SP222min
PLAY
04/05/06
AM
01:23:45 INS
OVER
dB010203040
OVER
W
SDI
Y/C
SYNC
VA
SDI
System
■ When an RS-422A-compatible remote controller is used:
For the editing remote controller, use RM-G820.
When connecting
•Perform this when the unit is off.
• Read the instruction manual of the unit before performing it.
Monitor Monitor
VIDEO
MONITOR
SDI IN
Remote cable
LAP
IN OUT SERVO LAP
FRAME
HOUR MIN SEC
EVENT No.
BUMP
V.SPEED
ON
OFF
A.SPLIT
DURATION
PREROLL
7
5
RESET
LAP
3
PLAYER
P
CONTINUE
END
EVENT
START
EJECT
AUX
REC REW FF STOP
X-1
REV
V.SPEED
MENU
RIPPLE
RENUMBER
MAN.TAKELEARN
SPLIT
ASSEM
VIDEO
AUD-2
AUD-1
STB OFF
SPLIT
CANCEL
+–
SEARCHPAUSE
PLAY
/STILL
OUTINENTRY
STILL
X1
MAX
AUTO EDIT
PREVIEW
ALL STOP
SHIFT
MIN
FWD
MONITOR
PLAYER
Recorder
SDI and/or AES/EBU
video/audio equipment
SYNC IN
REMOTE 1 (9-PIN)
RM—G820
EDITING CONTROL UNIT
IN OUT SERVO
IN
FRAME
HOUR MIN SEC
OUT
IN
OUT
PR
VITC
VITC
RESET
LTC
LTC
LAP
TOTAL
CTL
CTL
RECORDER
EJECT
REC REW FF STOP
STB OFF
TC
LAST
REC
SEARCHPAUSE
PLAY
ED
EE
/STILL
IN
OUT
STILL
X1
X-1
MAX
GOTO REVIEW
MIN
REV
FWD
MONITOR
RECORDER
AUDIO
MONITOR
LINE
IN
VIDEO
MONITOR
Player
COMPONENT
VIDEO
LINE
Y/C
IN
OUT
MONITOR
OUT
SIGNAL
GND
SYNC IN
B-YR-Y
Y
IN OUT
SYNC IN
TIME CODE
IN OUT
DV
SERIAL
IN/OUT
REMOTE
DC12V
B.B.
B.B.
B.B.
Synchronized signal generator
IN
OUT
OFF
REC PLAY
TIMER
REMOTE2
AUDIO
CH 1/3 CH 2/4
B.B.
IN
OUT
MONITOR
OUT
AUDIO
MONITOR
SDI OUT
AES/EBU OUT
REMOTE1
REMOTE 1 (9-PIN)
AES/EBU IN
SYNC IN
RM-G820
MEMO
• In order to enhance the level of editing precision, input synchronization signals (black
burst signals) to all devices.
• In order to synchronize the video output signal in E-E mode, input synchronization
signals into the LINE input of BR-DV6000 as well and set the input switch to “LINE”.
6
Specifications
■ General
Power : DC12 V(supplied from the VCR
installation)
Power consumption : 1.5 W
External dimension :
135.2 mm (W) 81 mm (H) 42 mm (D)
(Excluding protruding parts)
Weight : 150 g
Allowable operating temperature : 5°C to 40°C
Allowable storage temperature : –20°C to 60°C
Allowable operating RH : 30%RH to 80%RH
■ Video/Audio : [SDI OUT]
Output video signal : Serial digital signal
conforming to SMPTE259M
(EMBEDDED AUDIO) : Serial digital
signal conforming to SMPTE272M
Output impedance : 75 Ω (BNC) unbalanced
Output level : 800 mV (p-p) ±10%
■ External dimensions (Unit : mm)
■ Audio : [AES/EBU OUT]
Output audio signal : digital audio signal
conforming to AES/EBU
Output impedance : 75 Ω (BNC) unbalanced
Output level : 1.0 V (p-p)
18
42
38
SDI OUT
81
AES/EBU OUT
135.2
For improvement, the specifications and external appearance may be changed without prior notice.
7
SA-X65U SDI OUT
is a registered trademark owned by Victor Company of Japan, Limited.
is a registered trademark in Japan, the U.S.A., the U.K. and many other countries.
© 2004 Victor Company of Japan, Limited
Printed in Japan
LLT0065-001B
Loading...