JVC HZ-CA13U User Manual

INSTRUCTIONS

HZ-CA13U Cine Lens Adapter

Thank you for purchasing the HZ-CA13U Cine lens adapter.

HZ-CA13U is an adapter for mounting 16mm cine lens to JVC ProHD Camcorder.

Compatible camcorder : HZ-CA13U can be used on Camcorder which lens mounting method is 1/3-inch Bayonet type.

GY-HD100U/E, GY-HD101E, GY-HD110U/E, GY-HD111E, GY-HD200U/E, GY-HD201E

GY-HD250U/E, GY-HD251E

Pin Mounting Cine lens (PL Mount)

1/3-inch Bayonet Mount (For Camcorder)

1/4-inch UNC20 Screw hole

Attaching the Cine Lens Adapter to the Camcorder

Hol

Back focus adjust rin

1.Loosen the mount ring of the camcorder.

2.Attach the cine lens adapter with its pin aligned with the

hole in the mount.

3.Tighten the mount ring of the camcorder.

4.In the case of fixed-focus lens, adjust the lens focus to t ∞,

take picture of object (30m far away or above) and then

adjust using Back focus adjust ring such that the back focus

is adjusted properly.

5.When zoom lens is mounted, use Back focus adjust ring to

adjust if the back focus is out of adjustment. Firstly, set to

Telephoto position and adjust the lens focus, then set to

Wide-angle position and adjust using Back focus adjust ring

such that the focus is adjusted properly.

CAUTION

• Be sure to tighten the mount ring completely. Incomplete

tightening may result in the lens dropping off or disturbed

back focus.

• Set the Camcorder’s power switch to “OFF” before the zoom

lens is attached or detached.

• This adapter is exclusively for 16mm Cine lens.

• 1/4-inch UNC screw holes for lens support are provided on

this adapter. Attach the lens support always when using the

cine lens.

• When taking picture using this adapter, the image will be

displayed upside-down on the monitor. A menu to restore

the upside-down image is available on GY-HD200/201/250/

251.

Back Focus Adjust Ring

Specifications

Conversion Ratio : x 0.47

Aperture : f / 1.4

Size length : 138.2 mm (Mount to Mount)

Diameter : φ78 mm

Weight : 860 g

Mount for lens side : PL Mount

Mount for Camera side : 1/3-inch Bayonet Mount

 Dimensions (unit: mm)

F.B 52in air

138.2 (Mount to Mount)

PL Mount

φ78

1/4-inch UNC20

78.5

F.B 31in air

1/3-inch Bayonet

Mount

LST0570-001A