JVC GD-171, OAM0008, GD-191, MA-LMU179V, GD-191U User Manual

0 (0)
JVC GD-171, OAM0008, GD-191, MA-LMU179V, GD-191U User Manual

GD-171

GD-191

LCD MONITOR

User’s Guide

MA-LMU179V

P/NO.OAM0008

Please read this manual thoroughly before use, and keep it handy for future reference.

European Union only

European Union only

FCC NOTICE

- 1 -

CAUTION: Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

IMPORTANT RECYCLING INFORMATION

This product has a fluorescent lamp that contains mercury. Disposal of these materials may be regulated in your community due to environmental considerations. For disposal or recycling information, please contact your local authorities or for USA, the Electronic Industries Alliance: http://www.eiae.org

- 2 -

SAFETY INSTRUTIONS

1.Read all of these instructions.

2.Save these instructions for later use.

3.Follow all warnings and instructions marked on the product.

4.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

5.Do not use this product near water.

6.Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the product and persons nearby.

7.Slots and openings in the cabinet and the back are provided for ventilation: to ensure reliable operation of the product, these openings must not be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should never be placed near or over a heat register. This product should not be placed in a built-in installation unless proper ventilation is provided.

8.This product should be operated from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company.

9.This product is equipped with a 3-wire grounding type plug having a third (grounding) pin. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug.

10.Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord.

11.If an extension cord is used with this product, make sure that the total of the ampere ratings on the products plugged into the extension cord do not exceed the extension cord ampere rating. Also, make sure that the total of all products plugged into the wall outlet does not exceed 10 amperes.

12.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill any kind of liquid on the product.

13.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to service personnel.

14.Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions.

A.When the power cord or plug is damaged or frayed.

B.If liquid has been spilled into the product.

C.If the product has been exposed to rain or water.

D.If the Product does not operate normally when the operating instructions are followed.

Adjust only those controls that are covered by the operating instructions since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore normal operation.

E.If the product has been dropped or the cabinet has been damaged.

-3 -

SAFETY INSTRUTIONS

F.If the product exhibits a distinct change in performance, indicating a need for service.

15.The Main Plug is used as the disconnect device.

Make enough room for inserting and removing the power plug. Place the apparatus as close to the outlet as possible.

16.Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.

17.Do not step on or hang on the product.

CAUTION

The lightning flash with arrowhead symbol, within an equilateral triangle is Intended to alert the user

to the presence of uninsulated ‘dangerous voltage’ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.”

The exclamation point within an equilateral triangle is intended to alert the user to the presence important Operating and maintenance (servicing) instruction in the literature accompanying the appliance.

- 4 -

NEVER REMOVE THE BACK COVER

Removal of the back cover should be carried out only by qualified personnel.

DO NOT USE IN HOSTILE ENVIRONMENTS

To prevent shock or fire hazard, do not expose the unit to rain or moisture.

This unit is designed to be used in the office or home. Do not subject the unit to vibrations, dust of corrosive gases.

KEEP IN A WELL VENTILATED PLACE

Ventilation holes are provided on the cabinet to prevent the temperature from rising.

Do not cover the unit or place anything on the top of unit.

AVOID HEAT

Avoid placing the unit in direct sunshine or near a heating appliance.

TO ELIMINATE EYE FATIGUE

Do not use the unit against a bright back ground and where sunlight or other light sources will shine directly on the monitor.

BE CAREFUL OF HEAVY OBJECT

Neither the monitor itself nor any other heavy object should rest on the power cord.

Damage to a power cord can cause fire or electrical shock.

- 5 -

Loading...
+ 11 hidden pages