JVC DT-X71FI, DT-X71HI, DT-X71CI User manual

7" Portable On-camera LCD Monitor

Model:

DT-X71F

DT-X71H

DT-X71C

User Manual

HDSDI&HDMI, Waveform, Audio meter, Focus assist

3GSDI&HDMI

HDMI

Please read this User Manual

throughout before using.

Preface

Congratulations on your purchase of this product. Please read this user manual carefully.

1． All internal technologies of this product are protected, including device, software and trademark.

Reproduction in whole or in part without written permission is prohibited.

2． All brands and trademarks are protected and other relative trademarks in this user manual are the

properties of their respective owners.

3． Due to constant effort of product development, SWIT Electronics reserves the right to make changes and

improvements to the product described in this manual without prior notice.

4． The warranty period of this product is 2 years, and does not cover the following:

(1) Physical damage to the surface of the products, including scratches, cracks or other damage to the

LCD screen or other externally exposed parts;

(2) Misuse, abuse or negligent operation to the product;

(3) The product is disassembled by anyone other than an authorized service center.

It is considered normal that the LCD bright dot defects are not to exceed three.

5． For any suggestions and requirements on this product, please contact us through phone, fax, Email, etc.

SWIT Electronics Co., Ltd. / SWIT Electronics USA, LLC.

Address: 4300 Stevens Creek Blvd. Suite 230

San Jose, CA 95129

Toll free: 1 866 986-SWIT(7948)

Tel: [phone]

Fax: [phone]

Email: [e-mail]

Website: www.swit.us

Maintenance

 Monitor

1. Please keep the signal terminals and the cooling vent away from knife-edge, metal or liquid in order to

avoid short-circuit and damage.

2. Please don't try to disassemble any parts of the monitor by yourself, which would probably damage the

monitor and do harm to human body, and it will cause the invalidation of product warranty.

3. Please don't touch the screen with your fingers, which would probably deface the screen.

4. Please don't press the screen; the LCD is extremely exquisite and flimsy.

 The power

Please use the provided power adapter or the battery recommended by the manufacturer in order to

avoid damage. For a third party power adapter, please make sure the voltage range, supplied power, and

polarity of power lead are fit.

Please disconnect the power cable or take off the battery under the following situations:

1. If you do not operate this monitor for a period of time;

2. If the power cable or power adaptor is damaged;

3. If the monitor housing is broken.

 Working Environment

1. Please don't lay this product on the unstable place.

2. Please don't lay this product in hot, cold or wet location.

 Cleaning

1. Please clean the screen with dry and downy cloth or special LCD cleanser.

2. Please do not press hard when cleaning the screen.

3. Please do not use water or other chemical cleanser to clean the screen. The chemical may damage

the LCD.

4. For first time use, please tear off the factory LCD film. To protect the LCD screen, please post the LCD

protection film offered in the package.

1. Features

◆◆◆◆

New high resolution 7” LCD Panel

16:9, 1024×600, 16.77 million colors, 900:1

contrast, and H160°/ V160°viewing angle.

◆◆◆◆

Multiple inputs

2 HD/SD-SDI, 1 HDMI and 1 Composite input.

◆◆◆◆

Loop through outputs

Each of the 2 input HD/SD-SDI has loop through

output.

◆◆◆◆

HDMI converted to SDI output

Supported HDMI formats: 480i / 576i / 720p (50,

59.94, 60) / 1080i (50, 59.94, 60) / 1080P (23.98

24, 25, 29.97, 30), and the output SDI will embed

the audio (48KHz) from HDMI.

◆◆◆◆

Waveform (Y, Cb, Cr, R, G, B) and full scale

There are totally 6 kinds of waveform display,

available under both SDI and HDMI, to check the

Luminance (Y), Blue-difference (Cb),

Red-difference (Cr), Red (R), Green (G), Blue (B),

and the Y, Cb, Cr can be simultaneously displayed,

R, G, B can be simultaneously displayed, and

each of the waveforms can be set to full scale

display.

◆◆◆◆

Vector scope

The displayed vector scope pattern is available

under both SDI and HDMI, represents saturation

as distance from the center of the circle, and hue

as the angle, in standard position, around it.

◆◆◆◆

Histogram (R, G, B)

The histogram is a bar graph that shows the

distribution of luminance values in the picture.

There’re R, G, B histograms that individually

displayed simultaneously, available under both

SDI and HDMI.

◆◆◆◆

16-ch audio meter

Under HDSDI, it displays 16 channels audio bars,

with mark, and under SDSDI or HDMI, it displays

2 channels audio bars with mark. The audio bar is

green, and will turn yellow when audio exceeds

-20dB, and turn red when exceeds -10dB.

◆◆◆◆

SDI timecode

Under SDI input, it can display the SMPTE

timecode, which is used extensively for

synchronization, and for logging and identifying

material in recorded media.

DT-X71F

◆◆◆◆

Peaking focus assist (red/blue switch)

The Peaking focus assist function is to mark the

sharpest edges of the image with red or blue color,

for users to check if the subjects are focused.

◆◆◆◆

Zebra stripes

Zebra Stripes are used to check if the image is

over exposed or not by showing black and white

lines on the monitor. It is considered over exposed

when luminance value exceeds 90%.

◆◆◆◆

False color

The false color is used to aid in the setting of

camera exposure. Under false color mode, there’s

a false color key on the bottom of screen for

reference. The over exposed subjects (above 101

IRE) on the monitor will display as RED, and the

underexposed subjects will display as BLUE. For

correct exposed subjects, it will display as green

and pink.

◆◆◆◆

Blue Only

Under the Blue Only Mode, only the blue pixels

are used to generate the image, because hue and

saturation can be adjusted quicker and more

accurately.

◆◆◆◆

DSLR scale zoom in

The Canon DSLR outputs the CMOS sensor ratio

HDMI and this zoom in mode can make the

effective image scale full screen on the monitor.

◆◆◆◆

User definable function keys

There are 3 function keys on the monitor front

panel, that permit users to define shortcuts for the

various functions.

◆◆◆◆

User editable video title

User can edit a video title for the current camera,

and the title will display on the top of screen.

◆◆◆◆

Front and Rear 3-color TALLY light

2 TALLY lights design, to give “live” signals to

people in front of the camera, as well as the

camera operator behind.

◆◆◆◆

Image Flip

Set image to rotate by 180°.

◆◆◆◆

High resolution 7” LCD Panel

16:9, 1024×600, 16.77 million colors, 900:1

contrast, and H160°/ V160°viewing angle.

◆◆◆◆

3Gbps SDI support

Accepts 3G/HD/SD-SDI input.

◆◆◆◆

Multiple inputs

1 3G/HD/SD-SDI, 1 HDMI, 1 Composite input

and L/R stereo audio.

◆◆◆◆

Loop through outputs

1 3G/HD/SD-SDI, 1 HDMI and 1 Composite video

loop through output.

◆◆◆◆

SDI embedded audio output

The SDI embedded audio can be output through

3.5mm earphone on the front panel.

◆◆◆◆

Image Flip.

Set image to rotate by 180°

DT-X71H

◆◆◆◆

DSLR scale zoom in

The Canon DSLR outputs the CMOS sensor ratio

HDMI and this zoom in mode can make the

effective image scale full screen on the monitor.

◆◆◆◆

User definable function keys

There are 2 function keys on the monitor front

panel, that permit users to define shortcuts for the

various functions.

◆◆◆◆

User editable video title

User can edit a video title for the current camera,

and the title will display on the top of screen.

◆◆◆◆

Front and Rear 3-color TALLY light

2 TALLY lights design, to give “live” signals to

people in front of the camera, as well as the

camera operator behind.

◆◆◆◆

New high resolution 7” LCD Panel

16:9, 1024×600, 16.77 million colors, 900:1

contrast, and H160°/ V160°viewing angle.

◆◆◆◆

Multiple inputs

1 HDMI, 1 Composite input

and L/R stereo audio input.

◆◆◆◆

Loop through outputs

1 HDMI and 1 Composite loop through output.

◆◆◆◆

DSLR scale zoom in

The Canon DSLR outputs the CMOS sensor ratio

HDMI and this zoom in mode can make the

effective image scale full screen on the monitor.

◆◆◆◆

Image Flip

Set image to rotate by 180°.

DT-X71C

◆◆◆◆

User definable function keys

There are 2 function keys on the monitor front

panel, that permit users to define shortcuts for the

various functions.

◆◆◆◆

User editable video title

User can edit a video title for the current camera,

and the title will display on the top of screen.

◆◆◆◆

Front and Rear 3-color TALLY light

2 TALLY lights design, to give “live” signals to

people in front of the camera, as well as the

camera operator behind.